|
ATA5282 Datasheet, PDF (1/23 Pages) ATMEL Corporation – ULTRA LOW POWER 125 KHZ 3D WAKE UP RECEIVER WITH RSSI | |||
|
Features
⢠Three Input Channels for 3D Antennas
⢠2.8 mVPP Sensitivity Typically
⢠Ultra Low Current Operation Consumption
⢠2 µA Standby Current Typically
⢠4 µA Active Current Typically
⢠Power Supply 2 V to 4.2 V
⢠Carrier Frequency Range from 100 kHz to 150 kHz
⢠Wake-up Function for a Microcontroller
⢠Header Detection
⢠Baud Rate up to 4 kbps (ASK Modulation)
⢠Bi-directional Two-wire Interface
⢠ESD According to Automotive Requirements
Benefits
⢠Digital RSSI for Field Strength Measurement
⢠Coils Input Range from 2.8 mVPP to 2.8 VPP Typically
⢠High Sensitivity
Applications
⢠Passive Entry Go (PEG)/Car Access
⢠Position Indicator
⢠Home Access Control
⢠RFID Systems
Description
The ATA5282 is a 125-kHz ultra low power receiver IC with three input channels for
Passive Entry Go applications. It includes all circuits for an LF wake-up channel. The
three sensitive input stages of the IC amplifier demodulate and measure the input sig-
nal from the antenna coils. The microcontroller interface of the IC outputs the data
signal as well as the measured RSSI values. During standby mode, the header detec-
tion unit monitors the incoming signal and generates a wake-up signal for the
microcontroller if the IC receives a valid 125-kHz carrier signal.
By combining the IC with an antenna coil, a microcontroller, an RF transmitter/trans-
ceiver and a battery, it is possible to design a complete hands-free key for Passive
Entry Go applications.
Ultra Low Power
125 kHz 3D -
Wake-up
Receiver with
RSSI
ATA5282
Preliminary
Rev. 4694BâAUTOâ06/04
|
▷ |