|
AT91SAM7XC512 Datasheet, PDF (1/45 Pages) ATMEL Corporation – ARM Thumb-based Microcontrollers | |||
|
Features
⢠Incorporates the ARM7TDMI® ARM® Thumb® Processor
â High-performance 32-bit RISC Architecture
â High-density 16-bit Instruction Set
â Leader in MIPS/Watt
â EmbeddedICE⢠In-circuit Emulation, Debug Communication Channel Support
⢠Internal High-speed Flash
â 512 Kbytes (AT91SAM7XC512) Organized in Two Banks of 1024 Pages of 256 Bytes
(Dual Plane)
â 256 Kbytes (AT91SAM7XC256) Organized in 1024 Pages of 256 Bytes (Single Plane)
â 128 Kbytes (AT91SAM7XC128) Organized in 512 Pages of 256 Bytes (Single Plane)
â Single Cycle Access at Up to 30 MHz in Worst Case Conditions
â Prefetch Buffer Optimizing Thumb Instruction Execution at Maximum Speed
â Page Programming Time: 6 ms, Including Page Auto-erase,
Full Erase Time: 15 ms
â 10,000 Write Cycles, 10-year Data Retention Capability,
Sector Lock Capabilities, Flash Security Bit
â Fast Flash Programming Interface for High Volume Production
⢠Internal High-speed SRAM, Single-cycle Access at Maximum Speed
â 128 Kbytes (AT91SAM7XC512)
â 64 Kbytes (AT91SAM7XC256)
â 32 Kbytes (AT91SAM7XC128)
⢠Memory Controller (MC)
â Embedded Flash Controller, Abort Status and Misalignment Detection
⢠Reset Controller (RSTC)
â Based on Power-on Reset Cells and Low-power Factory-calibrated Brownout
Detector
â Provides External Reset Signal Shaping and Reset Source Status
⢠Clock Generator (CKGR)
â Low-power RC Oscillator, 3 to 20 MHz On-chip Oscillator and one PLL
⢠Power Management Controller (PMC)
â Power Optimization Capabilities, Including Slow Clock Mode (Down to 500 Hz) and
Idle Mode
â Four Programmable External Clock Signals
⢠Advanced Interrupt Controller (AIC)
â Individually Maskable, Eight-level Priority, Vectored Interrupt Sources
â Two External Interrupt Sources and One Fast Interrupt Source, Spurious Interrupt
Protected
⢠Debug Unit (DBGU)
â 2-wire UART and Support for Debug Communication Channel interrupt,
Programmable ICE Access Prevention
⢠Periodic Interval Timer (PIT)
â 20-bit Programmable Counter plus 12-bit Interval Counter
⢠Windowed Watchdog (WDT)
â 12-bit key-protected Programmable Counter
â Provides Reset or Interrupt Signals to the System
â Counter May Be Stopped While the Processor is in Debug State or in Idle Mode
⢠Real-time Timer (RTT)
â 32-bit Free-running Counter with Alarm
â Runs Off the Internal RC Oscillator
AT91 ARM
Thumb-based
Microcontrollers
AT91SAM7XC512
AT91SAM7XC256
AT91SAM7XC128
Summary
Preliminary
NOTE: This is a summary document.
The complete document is available on
the Atmel website at www.atmel.com.
6209BSâATARMâ03-Sep-06
|
▷ |