AT90S2323 Datasheet, PDF (1/64 Pages) ATMEL Corporation – 8-Bit Microcontroller with 2K Bytes of In-System Programmable Flash

Features
• Utilizes the AVR^® RISC Architecture
• AVR – High-performance and Low-power RISC Architecture
– 118 Powerful Instructions – Most Single Clock Cycle Execution
– 32 x 8 General-purpose Working Registers
– Up to 10 MIPS Throughput at 10 MHz
• Data and Nonvolatile Program Memory
– 2K Bytes of In-System Programmable Flash
Endurance: 1,000 Write/Erase Cycles
– 128 Bytes Internal RAM
– 128 Bytes of In-System Programmable EEPROM
Endurance: 100,000 Write/Erase Cycles
– Programming Lock for Flash Program and EEPROM Data Security
• Peripheral Features
– One 8-bit Timer/Counter with Separate Prescaler
– Programmable Watchdog Timer with On-chip Oscillator
– SPI Serial Interface for In-System Programming
• Special Microcontroller Features
– Low-power Idle and Power-down Modes
– External and Internal Interrupt Sources
– Power-on Reset Circuit
– Selectable On-chip RC Oscillator
• Specifications
– Low-power, High-speed CMOS Process Technology
– Fully Static Operation
• Power Consumption at 4 MHz, 3V, 25°C
– Active: 2.4 mA
– Idle Mode: 0.5 mA
– Power-down Mode: <1 µA
• I/O and Packages
– Three Programmable I/O Lines for AT90S/LS2323
– Five Programmable I/O Lines for AT90S/LS2343
– 8-pin PDIP and SOIC
• Operating Voltages
– 4.0 - 6.0V for AT90S2323/AT90S2343
– 2.7 - 6.0V for AT90LS2323/AT90LS2343
• Speed Grades
– 0 - 10 MHz for AT90S2323/AT90S2343-10
– 0 - 4 MHz for AT90LS2323/AT90LS2343-4
– 0 - 1 MHz for AT90LS2343-1
8-bit
Microcontroller
with 2K Bytes of
In-System
Programmable
Flash
AT90S2323
AT90LS2323
AT90S2343
AT90LS2343
Pin Configuration
PDIP/SOIC
RESET 1
(CLOCK) PB3 2
PB4 3
GND 4
8 VCC
RESET 1
7 PB2 (SCK/T0)
XTAL1 2
6 PB1 (MISO/INT0) XTAL2 3
5 PB0 (MOSI)
GND 4
8 VCC
7 PB2 (SCK/T0)
6 PB1 (MISO/INT0)
5 PB0 (MOSI)
AT90S/LS2343
AT90S/LS2323
Rev. 1004D–09/01
1