AT25F512A_06 Datasheet, PDF (1/19 Pages) ATMEL Corporation – 512Kbit High Speed SPI Serial Flash Memory

Features
• Serial Peripheral Interface (SPI) Compatible
• Supports SPI Modes 0 (0,0) and 3 (1,1)
– Datasheet Describes 0 Operation
• 33 MHz Clock Rate
• Byte Mode and 128-byte Page Mode for Program Operations
• Sector Architecture:
– Two Sectors with 32K Bytes Each
– 256 Pages per Sector
• Product Identification Mode
• Low-voltage Operation
– 2.7 (V_CC = 2.7 to 3.6V)
• Sector Write Protection
• Write Protect (WP) Pin and Write Disable Instructions for both Hardware and Software
Data Protection
• Self-timed Program Cycle (75 µs/byte typical)
• Self-timed Sector Erase Cycle (1 second/sector typical)
• Single Cycle Reprogramming (Erase and Program) for Status Register
• High Reliability
– Endurance: 10,000 Write Cycles Typical
– Data Retention: 20 Years
• 8-lead JEDEC SOIC and 8-lead SAP Packages
Description
The AT25F512A provides 524,288 bits of serial reprogrammable Flash memory orga-
nized as 65,536 words of 8 bits each. The device is optimized for use in many
industrial and commercial applications where low-power and low-voltage operation
are essential. The AT25F512A is available in a space-saving 8-lead JEDEC SOIC and
8-lead SAP packages.
The AT25F512A is enabled through the Chip Select pin (CS) and accessed via a
three-wire interface consisting of Serial Data Input (SI), Serial Data Output (SO), and
Serial Clock (SCK). All write cycles are completely self-timed.
Block write protection for the entire memory array is enabled by programming the sta-
tus register. Separate write enable and write disable instructions are provided for
additional data protection. Hardware data protection is provided via the Write Protect
(WP) pin to protect against inadvertent write attempts to the status register. The HOLD
pin may be used to suspend any serial communication without resetting the serial
sequence.
Table 1. Pin Configuration
Pin Name Function
CS
Chip Select
SCK
Serial Data Clock
SI
Serial Data Input
SO
Serial Data Output
GND
Ground
VCC
Power Supply
WP
Write Protect
HOLD
Suspends Serial Input
8-lead SOIC
CS 1
SO 2
WP 3
GND 4
8 VCC
7 HOLD
6 SCK
5 SI
8-lead SAP
VCC 8
HOLD 7
SCK 6
SI 5
1 CS
2 SO
3 WP
4 GND
Bottom View
512Kbit High
Speed SPI
Serial Flash
Memory
512K (65,536 x 8)
AT25F512A
Rev. 3345F–FLASH–11/06
1