AT25160_14 Datasheet, PDF (1/21 Pages) ATMEL Corporation – Low-voltage and Standard-voltage Operation

Features
• Serial Peripheral Interface (SPI) Compatible
• Supports SPI Modes 0 (0,0) and 3 (1,1)
• Low-voltage and Standard-voltage Operation
– 2.7 (V_CC = 2.7V to 5.5V)
– 1.8 (V_CC = 1.8V to 5.5V)
• 3.0 MHz Clock Rate (5V)
• 32-byte Page Mode
• Block Write Protection
– Protect 1/4, 1/2, or Entire Array
• Write Protect (WP) Pin and Write Disable Instructions for
both Hardware and Software Data Protection
• Self-timed Write Cycle (5 ms Typical)
• High-reliability
– Endurance: One Million Write Cycles
– Data Retention: 100 Years
• Automotive Grade Devices Available
• 8-lead PDIP, 8-lead JEDEC SOIC and 14-lead TSSOP Packages
Description
The AT25080/160/320/640 provides 8192/16384/32768/65536 bits of serial electri-
cally-erasable programmable read only memory (EEPROM) organized as
1024/2048/4096/8192 words of 8 bits each. The device is optimized for use in many
industrial and commercial applications where low-power and low-voltage operation
are essential. The AT25080/160/320/640 is available in space saving 8-lead PDIP, 8-
lead JEDEC SOIC and 14-lead TSSOP packages.
The AT25080/160/320/640 is enabled through the Chip Select pin (CS) and accessed
via a 3-wire interface consisting of Serial Data Input (SI), Serial Data Output (SO), and
Serial Clock (SCK). All programming cycles are completely self-timed, and no sepa-
rate ERASE cycle is required before WRITE.
SPI Serial
EEPROMs
8K (1024 x 8)
16K (2048 x 8)
32K (4096 x 8)
64K (8192 x 8)
AT25080
AT25160
AT25320
AT25640
Pin Configuration
Pin Name
CS
Function
Chip Select
SCK
SI
SO
Serial Data Clock
Serial Data Input
Serial Data Output
GND
VCC
WP
HOLD
Ground
Power Supply
Write Protect
Suspends Serial Input
NC
No Connect
DC
Don’t Connect
8-lead PDIP
CS 1
SO 2
WP 3
GND 4
8 VCC
7 HOLD
6 SCK
5 SI
8-lead SOIC
CS 1
SO 2
WP 3
GND 4
8 VCC
7 HOLD
6 SCK
5 SI
14-lead TSSOP
CS 1
SO 2
NC 3
NC 4
NC 5
WP 6
GND 7
14 VCC
13 HOLD
12 NC
11 NC
10 NC
9 SCK
8 SI
0675M–SEEPR–9/03
1