WS100 Datasheet, PDF (5/8 Pages) ASM GmbH – analog output Explosion-proof

Output Specifications
R1K and 10V for WS position sensors
Voltage divider R1K
Potentiometer
Excitation Voltage
Potentiometer Impedance
Thermal coefficient
Sensitivity
Signal diagram
Voltage Divider Utilization Range
Operating Temperature
+ Vin
+ Vout
GND
Excitation Voltage
Signal conditioner 10V _{Excitation Current}
Voltage output
Output Voltage
Output Current
Output Load
Stability (Temperature)
Protection
Output Noise
Operating Temperature
EMC
Signal diagram
10V
0...10 V
32 VDC max. at 1 kW (input power 1 W max.)
1 kW ±10%
±25 x 10^-6/ °C full scale
Depends on measurement range, individual
sensitivity of sensor specified on label
Approx. 3% ... 97% of full range
-20 ... +85 °C
Note: The potentiometer must be connected
as a voltage divider. The input impedance of
the following processing circuit should be 10
MW min.
+18 ... +27 V DC non stabilized
20 mA max.
0 ... +10 V DC
2 mA max.
> 5 kW
±50 x 10^-6 / °C full scale
Reverse polarity, short circuit
0,5 mVRMS
-20 ... +85 °C
According to EN 61326:2004
Excitation +
Excitation GND
Signal +
Signal GND
Signal Wiring
Connection
Mating Connector
Output signals
R1K
+ Vin
GND
+ Vout
10V
Excitation +
Excitation GND
Signal +
Signal GND
View to solder
terminals
Cable color
White
Brown
Green
Yellow
Connector
pin no.
1
2
3
4
CONN-DIN-8F-W
CONN-M12-8F-G
ASM
www.asm-sensor.com
CAT-WS-E-05
57