WS10ZG Datasheet, PDF (3/7 Pages) ASM GmbH – Analog, SSI or CANopen Output

Output Specifications
R1K and 10V for WS position sensors
Voltage divider R1K
Potentiometer
Excitation Voltage
Potentiometer Impedance
Thermal coefficient
Sensitivity
Signal diagram
Voltage Divider Utilization Range
Operating Temperature
+ Vin
+ Vout
GND
Excitation Voltage
Signal conditioner 10V _{Excitation Current}
Voltage output
Output Voltage
Output Current
Output Load
Stability (Temperature)
Protection
Output Noise
Operating Temperature
EMC
Signal diagram
10V
0...10 V
32 VDC max. at 1 kW (input power 1 W max.)
1 kW ±10%
±25 x 10^-6/ °C full scale
Depends on measurement range, individual
sensitivity of sensor specified on label
Approx. 3% ... 97% of full range
-20 ... +85 °C
Note: The potentiometer must be connected
as a voltage divider. The input impedance of
the following processing circuit should be 10
MW min.
+18 ... +27 V DC non stabilized
20 mA max.
0 ... +10 V DC
2 mA max.
> 5 kW
±50 x 10^-6 / °C full scale
Reverse polarity, short circuit
0,5 mVRMS
-20 ... +85 °C
According to EN 61326:2004
Excitation +
Excitation GND
Signal +
Signal GND
Signal Wiring
Connection
Mating Connector
Output signals
R1K
+ Vin
GND
+ Vout
10V
Excitation +
Excitation GND
Signal +
Signal GND
View to solder
terminals
Cable color
White
Brown
Green
Yellow
Connector
pin no.
1
2
3
4
CONN-DIN-8F-W
CONN-M12-8F-G
ASM
www.asm-sensor.com
CAT-WS-E-05
57