AX88178 Datasheet, PDF (1/37 Pages) ASIX Electronics Corporation – USB to 10/100/1000 Gigabit Ethernet/HomePNA Controller

AX88178
USB to 10/100/1000 Gigabit Ethernet/HomePNA Controller
Features
• Single chip USB to 10/100/1000 Gigabit Ethernet
and HomePNA and HomePlug Network Controller
• USB specification 1.0 and 1.1 and 2.0 compliant
• Supports USB Full and High Speed modes with
Bus power capability
• Supports 4 endpoints on USB interface
• High performance packet transfer rate over USB
bus using proprietary burst transfer mechanism
(submitted for US patent application)
• IEEE 802.3, 802.3u, and 802.3ab (10BASE-T,
100BASE-TX, and 1000BASE-T) compatible
• Embedded 20KB SRAM for RX packet buffering
and 20KB SRAM for TX packet buffering
• Supports both full-duplex and half-duplex
operation in Fast Ethernet
• Provides MII/GMII/RGMII interfaces for Ethernet
PHY interface and MII interface for HomePNA/
HomePlug PHY interface
• Supports Jumbo packet of up to 9KB
Document No: AX88178-07/6/21/05
• Supports Suspend mode and Remote Wakeup via
Link-up, Magic packet, or external pin
• Optional PHY power down during Suspend mode
• Supports 256/512 bytes (93c56/93c66) of serial
EEPROM (for storing USB Descriptors)
• Supports automatic loading of Ethernet ID, USB
Descriptors and Adapter Configuration from
EEPROM after power-on initialization
• External PHY loop-back diagnostic capability
• Integrates on-chip 3.3V to 2.5V voltage regulator
and requires only single power supply: 3.3V
• Small form factor with 128-pin LQFP package
• 12MHz clock input from either crystal or oscillator
source
• Operating temperature range: 0°C to 70°C.
*IEEE is a registered trademark of the Institute of Electrical and
Electronic Engineers, Inc.
*All other trademarks and registered trademark are the property of their
respective holders.
Product Description
The AX88178 USB to 10/100/1000 Gigabit Ethernet/HomePNA/HomePlug controller is a high performance and highly
integrated ASIC with embedded 40KB SRAM for packet buffering. It enables low cost and affordable Gigabit Ethernet
network connection to desktop, notebook PC, and embedded system using popular USB ports. It has an USB interface to
communicate with USB host controller and is compliant with USB specification V1.0, V1.1 and V2.0. It implements
10/100/1000Mbps Ethernet LAN function based on IEEE802.3, IEEE802.3u, IEEE802.3ab standards or HomePNA
standard. It supports media-independent interface (MII) to simplify the design on implementing Fast Ethernet and
HomePNA functions. It also provides gigabit media-independent (GMII) and reduced gigabit media-independent
(RGMII) interface for interfacing with Gigabit Ethernet PHY.
System Block Diagram
RJ45
Magnetic
10/100/1000 Gigabit Ethernet PHY
RJ11
Magnetic
1/10 Mbps Home LAN PHY
AX88178
EEPROM
USB I/F
Always contact ASIX for possible updates before starting a design.
This data sheet contains new products information. ASIX ELECTRONICS reserves the rights to modify product specification without notice. No
liability is assumed as a result of the use of this product. No rights under any patent accompany the sale of the product.
ASIX ELECTRONICS CORPORATION
4F, No. 8, Hsin Ann Rd., Science-Based Industrial Park, Hsin-Chu City, Taiwan, R.O.C.
TEL: [phone]
FAX: [phone]
Released Date: 6/21/2005
http://www.asix.com.tw/