ALN1750 Datasheet, PDF (1/3 Pages) Advanced Semiconductor Business Inc. – Internally Matched LNA Module

plerow^TM ALN1750
Internally Matched LNA Module
Features
· 27 dB Gain at 1750 MHz
· NF of 0.95 dB over frequency
· Unconditionally Stable
· Single 5V Supply
· High OIP3 @ Low Current
Description
The plerow^TM ALN-series is the compactly designed surface-mount
module for the use of the LNA with or without the following gain blocks in
the infrastructure equipment of the mobile wireless (CDMA, GSM, PCS,
PHS, WCDMA, DMB, WLAN, WiBro, WiMAX), GPS, satellite communi-
cation terminals, CATV and so on. It has an exceptional performance of
low noise figure, high gain, high OIP3, and low bias current. The stability
factor is always kept more than unity over the application band in order
to ensure its unconditionally stable implementation to the application
system environment. The surface-mount module package including the
completed matching circuit and other components necessary just in case
allows very simple and convenient implementation onto the system
board in mass production level.
Specifications (in Production)
Typ. @ T = 25°C, V_s = 5 V, Freq. = 1750 MHz, Z_o.sys = 50 ohm
Parameter
Specifications
Unit
Min
Typ
Max
Frequency Range
MHz
1700
1800
Gain
dB
26
27
Gain Flatness
Noise Figure
Output IP3 ⁽¹⁾
S11 / S22 ⁽²⁾
dB
dB
dBm
dB
± 0.5
± 0.7
0.95
1.0
32
33
-18 / -10
Output P1dB
Switching Time ⁽³⁾
Supply Current
dBm
17
18
µsec
-
mA
80
100
Supply Voltage
Impedance
Max. RF Input Power
V
Ω
dBm
5
50
C.W 29 ~ 31 (before fail)
Package Type & Size
mm
Surface Mount Type, 13Wx13Lx3.8H
Operating temperature is -40°C to +85°C.
1) OIP3 is measured with two tones at an output power of 10 dBm / tone separated by 1 MHz.
2) S11/S22 (max) is the worst value within the frequency band.
3) Switching time means the time that takes for output power to get stabilized to its final level after switching DC voltage from 0 V to V_S.
Outline Drawing (Unit: mm)
2-stage Single Type
More Information
Website: www.asb.co.kr
E-mail: [e-mail]
Tel: [phone]
Fax: [phone]
ASB Inc., 4th Fl. Venture Town
Bldg., 367-17 Goijeong-Dong,
Seo-Gu, Daejon 302-716, Korea
plerow
ALN1750
ASB Inc.
(Top View)
Solder Stencil Area
(Side View)
(Bottom View)
Pin Number
3
8
10
Others
Function
RF In
RF Out
+Vcc
Ground
Note: 1. The number and size of ground via holes in
a circuit board is critical for thermal RF
grounding considerations.
2. We recommend that the ground via holes be
placed on the bottom of all ground pins for
better RF and thermal performance, as
shown in the drawing at the left side.
Ø0.4 plated thru holes to ground plane
1/3
(Recommended Footprint)
www.asb.co.kr
September 2007