LCB150E Datasheet, PDF (2/3 Pages) Artesyn Technologies – 150 Watt Single Output Power Supply

LCB150 Data Sheet
Electrical Specifications
Output
Output rating
Output tolerance
Total regulation range
Rated load
Output noise (PARD)
See ordering information
± 1% to 2%
± 0.5% to 1%
90 - 158.4 W
100 - 200 mV p-p
Output voltage overshoot
Short circuit protection
Output isolation
Overload protection (OCP)
Overvoltage protection (OVP)
Output voltage adjust
Protected, no damage to occur
>105% rated output power
115% to 150%
± 10%
90 - 264 Vac
90 - 264 Vac
Combined line/load/transient when measured at output terminal
Derate linear to 50% from 50 °C to 70 °C
Main output
Measured with a 0.1 μF Ceramic and 10 μF Tantalum Capacitor on any output, 20 MHz
No overshoot/undershoot outside the regulation band during on or off cycle
Bounce mode
Standard per safety requirements
Main output
Main output
Main output
Environmental Specifications
Operating temperature
-25 °C to +70 °C, linear derating to 50% from 50 °C to 70 °C
Storage temperature
Humidity
-40 °C to +85 °C
20 to 90%, non-condensing
Vibration
10 - 500 Hz, 5G 10 min/1 cycle, period for 60 min each along X, Y, Z axes
Ordering Information
Model Number
LCB150E
LCB150L
LCB150N
LCB150Q
LCB150W
Output Voltage
5V
12 V
15 V
24 V
48 V
Output Current
18 A
12.5 A
10 A
6.5 A
3.3 A
Vo Adjust
± 10%
± 10%
± 10%
± 10%
± 10%
Output Power
90 W
150 W
150 W
156 W
158.4 W
Efficiency
83%
88%
89%
90%
90%
Miscellaneous Specifications
BURN-IN
100% Burn-in at 45 °C, at full load. Duration of burn-in determined by Quality Assurance Procedures.
MTBF
The power supply has a minimum MTBF of 244K hours according to MIL-HDBK-217F.
WARRANTY
Artesyn Embedded Technologies shall warrant the power supply to be free of defects in materials and workmanship for a minimum period
of two years from the date of shipment, when operated within specifications. The warranty shall be fully transferable to the end owner of
the equipment powered by the supply.