DS750PED-3-001 Datasheet, PDF (2/7 Pages) Artesyn Technologies – 750 Watts Distributed Power System

DS750PED Data Sheet
Electrical Specifications
Protections
Main Output
Overcurrent protection²
Overvoltage protection¹
Undervoltage protection
Overtemperature protection
Fan fault protection
Standby Output
Overcurrent protection³
Overvoltage protection³
Undervoltage protection
MIN
120%
13.5 V
10.5 V
120%
13.5 V
10.0 V
1 _{Latch mode}
2 _{Autorecovery if the overcurrent is less than 120% and last only for <500 ms}
3 _{Standby protection is auto-recovery}
Ordering Information
Model Number
DS750PED-3
DS750PED-3-001
Nominal Main Output
12 V @ 62.5 A
12 V @ 62.5 A
NOM
Yes
Yes
Standby Output
12 V @ 3 A
12 V @ 3 A
MAX
150%
15.0 V
11.0 V
150%
15.0 V
11.0 V
Airflow Direction
Standard (forward)
Reverse
Control and Status Signals
Input Signals
PSON_L
Active LOW signal which enables/disables the main output. Pulling this signal LOW will turn-on the main output. Recommended pull-up resistor to 12 VSB is 8.2 k
with a 3.0 k pull-down to ground. A 100 pF decoupling capacitor is also recommended.
MIN
MAX
V_IL
V_IH
I_SOURCE
I_SINK
PSKILL_L
Input logic level LOW
Input logic level HIGH
Current that may be sourced by this pin
Current that may be sunk by this pin at low state
2.0 V
0.8 V
5.0 V
2 mA
0.5 mA
First break/last mate active LOW signal which enables/disables the main output. This signal will have to be pulled to ground at the system side with a 220 ohm
resistor. A 100 pF decoupling capacitor is also recommended.
MIN
MAX
V_IL
V_IH
I_SOURCE
I_SINK
Input logic level LOW
Input logic level HIGH
Current that may be sourced by this pin
Current that may be sunk by this pin at low state
2.0 V
0.8 V
5.0 V
2 mA
0.5 mA