SIL20C2-00SADJ-HJ_15 Datasheet, PDF (1/4 Pages) Artesyn Technologies – C-Class Non-Isolated POWER

POWER
Data Sheet
SIL/SMT20C2 Series
C-Class Non-Isolated
Total Power: 20 Amps
Input Voltage: 4.5 - 13.8 Vdc
# of Outputs: Single
SPECIAL FEATURES
ƒƒ 20 A current rating
ƒƒ Input voltage range: 4.5 - 13.8 Vdc
ƒƒ Output voltage: 0.59 - 5.1 V
ƒƒ Industry-leading value
ƒƒ Cost optimized design
ƒƒ Excellent transient response
ƒƒ Output enable
ƒƒ Output voltage adjustability
ƒƒ Path for future upgrades
ƒƒ Supports silicon voltage migration
ƒƒ Reduced design-in and qual time
ƒƒ Current sink capability
ƒƒ RoHS compliant
ƒƒ Two year warranty
SAFETY
ƒƒ UL, cUL CAN/CSA 22.2 No.
ƒƒ TÜV Product Service (EN60950)
ƒƒ CB report and certificate to
IEC60950
Electrical Specifications
Input
Input voltage ra­nge
Input current
Minimum load
Remote OFF
Input current (max.)
See Note 3
Start-up time
Remote ON/OFF
Output
Output voltage
See Note 5
Output setpoint accuracy
0.1% trim resistors
Line regulation
Low line to high line
Load regulation
Full load to min. load
Min./max. load
Overshoot
At turn-on
Undershoot
At turn-off
Ripple and noise
5 Hz to 20 MHz
See Note 1
Transient response
See Note 1, 2
General
Efficiency
Switching frequency
Material flammability
Approvals and standards
Weight
MTBF
Coplanarity
Vin = 5 V, Vo = 2.5 V, lo = 20 A
Fixed
12 V @ 40 °C, 100% load
Bellcore 332
4.5 - 13.8 Vdc
50 mA
5 mA
18 A @ lo max.
3 ms
0.59 - 5.1 V
±1.0%
±0.2%
±0.5%
0 A/20 A
0.5% max.
100 mV max.
30 mV
Vin = 5 V, Vout = 2.5 V
130 mV max. deviation; 50 μs
recovery to within regulation band
90%
750 kHz
UL94V-0
EN60950; UL/cUL6950
8.50 g (0.03 oz.)
6,721,853 hours
150 μm
All specifications are typical at nominal input, full load at 25 °C, unless otherwise stated.