PM600 Datasheet, PDF (1/2 Pages) Artesyn Technologies – Single and dual output 0.5 to 1 Watt Nominal input DC/DC converters

[ 2 YEAR WARRANTY ]
PM600 SERIES
Single and dual output
• 24 pin DIP package
• 1.25 x 0.8 x 0.4 inch package
• Tight regulation
• Pi input filter
• 20mV pk-pk ripple and noise
• Short circuit protection
The PM600 Series are a broad line of low cost, high performance single and
dual output DC/DC converters packaged in an IC compatible 24 pin DIP
configuration. These miniature converters are ideal for use on high density PC
boards, or wherever low power, isolated and regulated outputs are required. A
self contained input Pi network filter, available on all models, minimizes reflected
ripple current for critical applications. This feature eliminates the need for
external filters thus reducing overall system cost. The PM600 series maintain
±0.3% line and ±0.4% load regulation, and require no derating over the
specified operating temperature range. Other specifications include: output
voltage accuracy, ±5.0%; ripple and noise, 20mV pk-pk; isolation, 300VDC.
PM600 series DC/DC converters are intended for a wide variety of industrial
applications, especially where tight regulation is required.
SPECIFICATION All specifications are typical at nominal input, full load at 25°C unless otherwise stated
OUTPUT SPECIFICATIONS
Voltage accuracy
±5.0%, max.
Line regulation
LL to HL
±0.3%
Load regulation
NL to FL
±0.4%
Ripple and noise
20MHz BW
See Note 5
20mV pk-pk, max.
Transient response
Overshoot for
10% to 90% FL
±0.1%, typical
Temperature coefficient
±0.01%°C, typical
Short circuit protection Output thermal
limited
Continuous
automatic recovery
INPUT SPECIFICATIONS
Input voltage range
5VDC, See Note 10 4.5 to 5.5VDC
12VDC, See Note 10 10.8 to 13.2VDC
Input filter
See Note 8
Pi network
Fault current mode
150% of FL
input current
GENERAL SPECIFICATIONS
Efficiency
50% typical
Isolation voltage
300VDC
Switching frequency Variable
40kHz to 70kHz
Case material
UL94V-0
Non-conductive
black plastic
Weight
14g (0.5oz)
MTBF
(75% FL)
Single Outputs
Dual Outputs
434,000 hours
268,000 hours
ENVIRONMENTAL SPECIFICATIONS
Thermal performance
Operating ambient –25°C to +71°C
Non-operating amb., –40°C to +125°C
Case
+95°C, max.
Derating
None required
Cooling Free air convection cooled
Relative humidity
Non-condensing
20% to 95% RH
Altitude
Operating
Non operating
10,000 feet max.
40,000 feet max.
Vibration
5Hz to 500Hz
2.5G rms (approx.)
PAGE 1