NTS503-M Datasheet, PDF (1/5 Pages) Artesyn Technologies – Active power factor correction

POWER
Data Sheet
Total Power: 200 - 500 Watts
Input Voltage: 85 - 264 Vac
120 - 300 Vdc
# of Outputs: Single
SPECIAL FEATURES
ƒƒ Active power factor correction
ƒƒ IEC EN61000-3-2 compliance
ƒƒ Remote sense
ƒƒ Power fail and remote inhibit
ƒƒ Single wire current sharing
ƒƒ Built-in EMI filter
ƒƒ Low output ripple
ƒƒ 5 V standby
ƒƒ 12 V fan output
ƒƒ Overvoltage protection
ƒƒ Overload protection
ƒƒ Thermal overload protection
ƒƒ DC power good
ƒƒ Built in OR-ing diode/FET
ƒƒ Optional fan cover (-CF suffix)
ƒƒ Optional end fan cover (-CEF suffix)
ƒƒ PMBus compliant
ƒƒ RoHS compliant
ƒƒ Digital I²C interface
ƒƒ Two year warranty
ƒƒ POE isolation on NTS508-M
SAFETY
ƒƒ TUV:
ƒƒ cULus:
ƒƒ CB:
ƒƒ CE:
60601-1
60601-1
Certificate & report
Mark (LVD)
NTS500-M Series
500 Watts
Medical
Electrical Specifications
Input
Input ra­nge
85 - 264 Vac (wide range)
Frequency
47 - 63 Hz
Inrush current
50 A max., cold start @ 25 °C
Efficiency
85% typical at full load, nominal line
EMI filter
FCC Class B conducted and radiated; CISPR22 Class B conducted
and radiated; EN55022 Class B conducted and radiated;
VDE0878PT3 Class B conducted and radiated.
Safety ground leakage
current
< 0.3 mA @ 50/60 Hz, 264 Vac input
Output
Maximum power
200 W for convection; 500 W with 30 CFM forced air
Adjustment range
± 5%
Standby output
5 V @ 1 A convection, 2 A forced air, regulated, ± 5%
Fan output
12 V @ 1 A, -5 %, +7%, 0.5 A for -CF version
Hold-up time
20 ms @ 500 W load, 115 VAC nominal line at factory voltage setting
Overload protection
Short circuit protection on all outputs. Case overload protected @
115 - 130% above peak rating
Overvoltage protection
20 - 35% above nominal output