English
Language : 

N1500 Datasheet, PDF (1/4 Pages) Artesyn Technologies – Single, and dual output 1500 and 2000 Watt AC/DC high wattage power supplies with PFC
N1500 and N2000 SERIES
Single, and dual output
[ 2 YEAR WARRANTY ]
• Active harmonic correction to EN61000-3-2
• 180VAC to 264VAC input voltage range
• Flexible output voltage configuration
• Two output power ratings
• Forced current sharing, all outputs
• DC OK (including LED)
• UL, CSA and TÜV safety approvals
• Industry standard 5 x 8 x 11 inch footprint
The N1500 and N2000 series are a range of system-orientated, single or dual output
power supplies with output powers of 1500W and 2000W. Harmonically corrected, they
operate from 180VAC to 264VAC. World wide safety approvals are standard. Fan
cooled and enclosed in the industry standard 5 x 8 x 11 inch form, the N1500 and N2000
series are an ideal choice when the economy and predictable performance of a
centralized system power supply are desired. By utilizing dual high current converters,
operating independently or together, a wide variety of output voltage and current
combinations can be factory configured. The N1500 and N2000 extend the range of the
N1000 family. Forced current share provides higher current to satisfy needs in large
systems, or to power expansion chassis. Dual output models at 5VDC/12VDC are
perfect to power mass storage systems. Other applications might use 5VDC/3.3VDC,
both operating at high currents. Single output versions, operating alone or in redundant
mode provide an economic power source for distributed systems. System interface
signals include AC and DC good, current monitor (V1). OVP, OCP, overtemperature
protection, remote enable, margin check inhibit as standard. By combining robust
performance and broad range, the N1500 and N2000 series sets the standard for
centralized system power supplies.
SPECIFICATION All specifications are typical at nominal input, full load at 25°C unless otherwise stated
OUTPUT SPECIFICATIONS (2)
Voltage adjustability Accessible at front panel
±10%
Remote sense
Open/reverse sense lead protection
Compensates for voltage drop of up to
0.5V to the load
Regulation, line or load All outputs, NL-FL
at nominal line or all
line variations at FL
±0.2%;
10mV min.
Cross regulation
0.2% max. or 10mV between outputs
Overshoot/undershoot
None at turn-on/off
Transient response
Main output
25% step load
change at 1A/µs
≤2.0% max. dev.,
≤200µs recovery
to 1.0%
Temperature coefficient
±0.02%/°C
Ripple and noise
0Hz to 20MHz 50mV pk-pk or 1.0%
Overvoltage protection Reset by cycling AC
115 to 130%
of nominal
Overload protection
105-115% full load
Short circuit protection All outputs
Auto recovery
Thermal protection
Auto shutdown, AC reset
Current sharing
±5.0%
50% to 100% load
Current monitor (V1) 5VDC at full load
±0.5V
INPUT SPECIFICATIONS
Input voltage range
180 to 264VAC
Input frequency range
47Hz to 63Hz
Input surge current
Meets IEEE std. 587.1980;
3KV ring wave
Input current
230VAC, 2000W
13A
Power factor
230VAC, 2kW load
0.98 min.
Power up time
Full load
1.0s max.
PAGE 1
EMC CHARACTERISTICS
Radiated emissions
Conducted emissions
Harmonic distortion
Electrostatic discharge
RF field susceptibility
Electrical fast
transients/bursts
Surge susceptibility
EN55022/11, FCC part 15
EN55022/11, FCC part 15
EN61000-3-2
EN61000-4-2
EN61000-4-3
EN61000-4-4
EN61000-4-5
Level A
Level A
Conforms
Level 3
Level 3
Level 3
Level 3
GENERAL SPECIFICATIONS
Hold-up time
180VAC, 2kW load
15ms min.
Efficiency
230VAC, full load
73%
Isolation voltage
Input/output
Input/chassis
Output/output
3000VAC
1500VAC
500VAC
Switching frequency
100kHz
Approvals and
standards
EN60950, UL1950,
CSA C22.2 No. 950
Weight
6.9kg (15Ibs)
Size
5 x 8 x 11 inches
127 x 203.2 x 279.4 mm
MTBF
per MIL-HDBK-217E 100,000 hours
ENVIRONMENTAL SPECIFICATIONS
Thermal performance Operating ambient
Non-operating
0°C to +50°C
-15°C to +85°C
Cooling
60CFM Internal DC ball bearing fan
Relative humidity
Non-condensing
0% to 95% RH
Altitude
Operating
Non-operating
6,000 feet max.
55,000 feet max.
Vibration
5Hz to 500Hz
2.4G rms peak