LPS353-CEF Datasheet, PDF (1/3 Pages) Artesyn Technologies – 350 Watts

Embedded Power for
Business-Critical Continuity
LPS350 Series
350 Watts
Total Power: 350 Watts
Input Voltage: 85-264 Vac
120 - 300 Vdc
# of Outputs: Single
Rev. 11.27.12
LPS350 Series
1 of 3
Special Features
• Active power factor correction
• IEC EN61000-3-2 compliance
• Remote sense on
• Power fail and remote inhibit
• Single wire current sharing
• Built-in EMI filter
• 2 Supervisory output 5 V and 12 V
• Overvoltage protection
• Overload protection
• Thermal overload protection
• DC power good
• 130 KHz switching frequency
• Optional with fan cover -CF
• Cover -C
• Optional end-mounted fan -CEF
Safety
VDE 0805/EN60950 (IEC950)
21310-3336-0001
UL
UL1950 EI86249
CSA
CSA 22.2-234 Level 5
LR109492C
NEMKO EN 60950/EMKO-TUE
P98102115 (74-sec) 203
BABT
EN60950/BS7002 608857,
608858, 609097
CB
Certificate and report
5734, 6280, 6281
CE
Mark (LVD)
Electrical Specifications
Input
Input ra­nge
85 - 264 VAC; 120 - 300 VDC
Frequency
47 - 440 Hz
Inrush current
38 A max, cold start @ 25 °C
Efficiency
EMI filter
75% typical at full load
FCC Class B conducted and radiated
CISPR 22 Class B conducted and radiated
EN55022 Class B conducted and radiated
VDE 0878 PT3 Class B conducted and radiated
Power factor
Safety ground
leakage current
Output
0.99 typical
0.5 mA @ 50/60 Hz, 264 VAC input
Maximum power
With cover: 350 W with 30 CFM forced air, (-C) (-CF) (-CEF)
Adjustment range
2:1 wide ratio
Supervisory output 5 V @ 500 mA regulated, 12 @ 150 mA x2
Hold-up time
Overload protection
20 ms @ 350 W load, 115 VAC nominal line at factory voltage settings
Short circuit protection on all outputs. Case overload protected @
110 - 145% above peak rating
Overvoltage protection 5 V output: 5.7 - 6.7 VDC. Other models 10% to 25% above nominal output