AQFV480E Datasheet, PDF (5/7 Pages) Arch Electronics Corp. – AC-DC Switching Power Supply

AQFV480E SERIES (CV Mode)
VER : B_3 update : 2012.05.03
AC-DC Switching Power Supply
480 Watts
FUNCTION DESCRIPITON of CN4 :
Pin No.
C1
C2
C3
C4
C5
C6
C7
C8
Function
+S
-S
+RC
-RC
DC-OK
GND
+5V SB
-5V SB
Description
Positive sensing. The +S signal should be connected to the positive terminal of the load.
The +S and -S leads should be twisted in pair to minimize noise pick-up effect.
The maximum line drop compensation is 0.5V. (max.)
Negative sensing. The -S signal should be connected to the negative terminal of the load.
The -S and +S leads should be twisted in pair to minimize noise pick-up effect.
The maximum line drop compensation is 0.5V. (max.)
Turns the output on and off by electrical or dry contact between pin C4 (-RC), Short: Power OFF, Open: Power ON.
Remote control ground.
DC-OK Signal is a DC output, referenced to pinC6(DC-OK GND).
This pin connects to the negative terminal(-V). Return for DC-OK signal output.
Stand by voltage output ground 4.5~5.5V, referenced to pin C8(-5V SB). The maximum load current is 0.6A.
Stand by voltage output ground.
FUNCTION MANUAL :
1. Remote Sense
The remote sensing compensates voltage drop on the load wiring up to 0.5V. (max.)
2. DC-OK Signal
Between DC-OK(pinC5)
and GND(pinC6)
4~6V
0~1V
Output
Status
ON
OFF
3. Remote Control
It can be turned ON/OFF by using the "Remote Control" function.
Between RC+(pinC3) and
RC-(pinC4)
SW ON (Short)
SW OFF (Open)
Output
Status
OFF
ON
http://www.archcorp.com.tw
TEL: [phone] FAX: [phone]
-5-