PLF25_SERIES Datasheet, PDF (1/2 Pages) Arch Electronics Corp. – Constant Current

PLF25 SERIES
KEY FEATURES
„ Fully Isolated Plastic Case with IP67 Level
„ Constant Current
„ With P.F.C. Function, PF>0.9
„ High Efficiency up to 85%
„ Free Air Convection
„ Protections: Over Load / Over Voltage /
.Short Circuit
„ High Reliability & Double Layered PCB
„ Ultra Compact Size: 3.15 x 1.5 x 1.1 Inches
„ 2-Years Product Warranty
VER : PA_2 update : 2010.10.20
LED Power
25 Watts
ELECTRICAL SPECIFICATIONS
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
Model No.
Max output wattage ( W )
Voltage (Note2)
Frequency (Hz)
Input
Power factor
Current (Full load)
Inrush current
Voltage (V.DC.) (max)
Constant Current Operation Voltage (max) (CC Mode) (Note3)
Output
Current Tolerance
Current Range (mA)
Ripple & Noise (max) (Note1)
Efficiency (typ)
Over current protection
Protection
Over voltage protection
Short circuit protection
Input-Output (V.AC)
Isolation
Input-FG (V.AC)
Output-FG .(V.AC)
Operating temperature
Storage temperature
Environment Temperature coefficient
Humidity
MTBF
Dimension (L x W x H)
Physical
Weight
Cooling method
Safety Standards
EMI (Conducted & Radiated Emission)
Safety & EMC
EMS (Noise Immunity)
Harmonic Current
PLF25-18S
PLF25-24S
PLF25-36S
25.2W
90-277 VAC
50 / 60 Hz
PF>0.92 at Full load (115 VAC) / PF>0.9 at Full load (230 VAC)
0.7A max. (115 VAC) / 0.35A max. (230 VAC)
40 A max. (Cold Start at 230 VAC)
18V
24V
36V
13.5~18VDC
18~24VDC
27~36VDC
±5%
1400
1050
700
3Vp-p
83%
84%
85%
Auto recovery
Zener diode clamp
Auto recovery
3000V
1500V
500V
-30°C…+70°C (with derating)
-40°C…+85°C
0.02%/°C
95% RH
>643,000 h @ 25°C (MIL-HDBK-217F)
3.15 x 1.5 x 1.1 Inches ( 80.0 x 38.1 x 28.0 mm ) Tolerance ±0.5 mm
150 g
Free air convection
Design refer to EN61347、EN61347-2-13、UL8750 (Pending)
Design refer to EN 55015 (Pending)
Design refer to EN 61547 (Pending)
Design refer to EN 61000-3-2、EN 61000-3-3 (Pending)
Note:
1. Ripple & Noise are measured at 20MHz of bandwidth with 0.1uF & 47uF parallel capacitor.
2.Please check the derating curve for more details.
3.This is the suitable operation region for LED related application.but please reconfirm special electrical requirements for some specific
ststem design.