TM9329PM Datasheet, PDF (1/1 Pages) API Technologies Corp – RF AMPLIFIER MODEL

RF AMPLIFIER
MODEL TM9329PM
Available as:
TM9329PM, 4 Pin TO-8 (T4)
TN9329PM, 4 Pin Surface Mount (SM3)
FP9329PM, 4 Pin Flatpack (FP4)
BX9329PM, Connectorized Housing (H1)
Features
! Superior Phase Noise Performance
! High Output Power + 20 dBm Typical
! High Third Order Intercept: +39 dBm Typical
! Operating Temp. -55 ºC to +85 ºC
Specifications
CHARACTERISTIC
Frequency
Gain (dB)
Power @ 1 dB
Comp. (dBm)
Reverse
Isolation (dB)
VSWR
In
Out
Noise Figure (dB)
TYPICAL
Ta= 25 ºC
10 - 1500 MHz
9.5
+20.0
-16
<1.5:1
<1.5:1
*4.0
MIN/MAX
Ta = -55 ºC to +85 ºC
10 - 1500 MHz
8.5 Min.
+19.0 Min.
-15 Max.
2.0:1
2.0:1
*8.0 Max.
Power Vdc
+15
+15
mA
90
95 Max.
Note: Care should always be taken to effectively ground the case of each unit.
* NOISE FIGURE IS HIGHER FOR FREQUENCIES BELOW 50 MHZ
Typical Intermodulation Performance at 25 ºC
Second Order Harmonic Intercept Point ....... +53 dBm (Typ.)
Second Order Two Tone Intercept Point ........ +48 dBm (Typ.)
Third Order Two Tone Intercept Point ............ +39 dBm (Typ.)
Maximum Ratings
Ambient Operating Temperature ............... -55ºC to +100 ºC
Storage Temperature ................................ -62ºC to +125 ºC
Case Temperature ................................................. +125 ºC
DC Voltage .......................................................... +18 Volts
Continuous RF Input Power .................................. +20 dBm
Short Term RF Input Power .... 200 Milliwatts (1 Minute Max.)
Maximum Peak Power ................... 0.5 Watt (3 µsec Max.)
Guaranteed @ 25 ºC (600 MHz) Phase Noise Performance (dBc/Hz)*
Frequency
Typical
Guarantee (Min.)
100 Hz
-147
-143
1 kHz
-157
-153
10 kHz
-165
-161
100 kHz
-173
-169
1 MHz
-177
-173
*Note: Phase Noise Performance typically tested at midband.
Bandedge performance may vary.
Typical Performance Data
Gain (dB)
11
10
9
8
0 ^{Reverse Isolation (dB)}
-13 0
- 10
-1 40
- 20
- 30
-1 50
Phase Noise (dBc/Hz)
7
- 40
-1 60
Start 10 MHz
Sto p 150 0 MHz
+24
1 dB Comp. (dBm)
Start 10 MHz
Stop 1500 MHz
Noise Figure (dB)
10
-1 70
+22
8
-1 80
+20
6
+18
-19 0
4
100
1K
1 0K
10 0K
1M
+16
2
Typical
Start 10 MHz
Stop 15 00 MHz
Start 10 MHz
Stop 1 500 MH z
Input VSWR
Output VSWR
2.0
2.0
PhaseNoise Test Conditions:
Carrier Frequency: 600 MHz
Power Output: +19.5 dBm
1.5
1.5
Temperature: 25 ºC
Agilent ES5500 System
1.0
Start 10 MHz
Legend
1.0
Stop 1500 MHz
Start 10 MHz
+25 ºC
+85 ºC - - - - - - -55 ºC
Stop 1500 MHz
Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH [phone] · Fax [phone]
www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pennsylvania 19154 · PH [phone] · Fax [phone]