TM6010PM Datasheet, PDF (1/1 Pages) API Technologies Corp – RF AMPLIFIER MODEL

RF AMPLIFIER
MODEL TM6010PM
Available as:
TM6010PM, 4 Pin TO-8 (T4)
TN6010PM, 4 Pin Surface Mount (SM3)
FP6010PM, 4 Pin Flatpack (FP4)
BX6010PM, Connectorized Housing (H1)
Features
Superior Phase Noise Performance
High Output Power: +23 dBm Typical
High Third Order Intercept: +36 dBm Typical
Low +10 volt Supply
Environmental Screening Available
Specifications
CHARACTERISTIC
Frequency
Gain (dB)
Power @ 1 dB
Comp. (dBm)
Reverse
Isolation (dB)
VSWR
In
Out
Noise Figure (dB)
TYPICAL
Ta= 25 ºC
5 - 500 MHz
14.5
+23
-18
<1.4:1
<1.2:1
4.6
MIN/MAX
Ta = -55 ºC to +85 ºC
5 - 500 MHz
13.0 Min.
+20 Min.
-15 Max.
2.0:1 Max.
2.0:1 Max.
6.0 Max.
Power
Vdc
+10
mA
145
+10
150 Max.
Note: Care should always be taken to effectively ground the case of each unit.
Typical Intermodulation Performance at 25 ºC
Second Order Harmonic Intercept Point ....... +56 dBm (Typ.)
Second Order Two Tone Intercept Point ........ +50 dBm (Typ.)
Third Order Two Tone Intercept Point ............ +36 dBm (Typ.)
(Absolute) Maximum Ratings
Ambient Operating Temperature ................ -55ºC to +100 ºC
Storage Temperature ................................. -62ºC to +125 ºC
Case Temperature .................................................. +125 ºC
DC Voltage ...........................................................+12 volts
Continuous RF Input Power .................................. +13 dBm
Short Term RF Input Power ............. 50 mW (1 Minute Max.)
Maximum Peak Power .................... 0.5 Watt (3 µsec Max.)
* ^{Guaranteed Phase Noise Performance (dBc/Hz)}
Frequency
100 Hz
1 kHz
10 kHz
100 kHz
1 MHz
Typical
-156
-170
-175
-175
-175
Guaranteed
-152
-168
-172
-172
-172
16
Gain (dB)
Typical Performance Data
+ 10
Reverse Isolation (dB)
-130
Phase Noise (dBc/Hz)
15
0
-140
14
- 10
13
- 20
-150
12 _{Start 5 MHz}
- 30
Stop 500 MHz
Start 5 MHz
-160
Stop 500 MHz
+24
1 dB Comp. (dBm)
7
Noise Figure (dB)
-170
+23
+22
+21
+20 _{Start 5 MHz}
2.0
1.5
1.0 _{Start 5 MHz}
Input VSWR
6
5
4
Stop 500 MHz ³ Start 5 MHz
2.0
1.5
Stop 500 MHz ^1.0 Start 5 MHz
-180
-190
100
1k
10 k
100 k
1M
_________Guarantee __ __ __ __Typical
Stop 500 MHz
Output VSWR
* Residual Phase Noise Test Conditions
Carrier Frequency: 500 MHz
Power Output: +23 dBm
Temperature: 25 ºC
Agilent ES5500 System
Stop 500 MHz
Legend
+25 ºC
+85 ºC - - - - - - -55 ºC
Rev.
Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH [phone] · Fax [phone]
www.SpectrumMicrowave.com ^{Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pennsylvania 19154 · PH [phone] · Fax [phone]}