TM5150PM Datasheet, PDF (1/1 Pages) API Technologies Corp – RF AMPLIFIER MODEL

RF AMPLIFIER
MODEL TM5150PM
Available as:
TM5150PM, 4 Pin TO-8 (T4)
TN5150PM, 4 Pin Surface Mount (SM3)
FP5150PM, 4 Pin Flatpack (FP4)
BX5150PM, Connectorized Housing (H1)
Features
! Low Noise Figure: 2.5 dB Typical
! Output Power: +18 dBm Typical
! Operating Temp. -55 ºC to +85 ºC
! Environmental Screening Available
Specifications
CHARACTERISTIC
Frequency
Gain (dB)
Power @ 1 dB
Comp. (dBm)
Reverse
Isolation (dB)
VSWR
In
Out
Noise Figure (dB)
TYPICAL
Ta= 25 ºC
10 - 300 MHz
20.0 +5
+18
-23
1.75:1
1.5:1
2.5
MIN/MAX
Ta = -55 ºC to +85 ºC
10 - 300 MHz
19.0 Min.
+17 Min.
-22 Max.
2.5:1 Max.
2.0:1 Max.
3.5 Max.
Power
Vdc
+15
mA
47
+15
53 Max.
Note: Care should always be taken to effectively ground the case of each unit.
Typical Intermodulation Performance at 25 ºC
Second Order Harmonic Intercept Point ....... +48 dBm (Typ.)
Second Order Two Tone Intercept Poin ......... +43 dBm (Typ.)
Third Order Two Tone Intercept Point ............ +32 dBm (Typ.)
Absolute Maximum (No Damage) Ratings
Ambient Operating Temperature ................ -55ºC to +100 ºC
Storage Temperature ................................. -62ºC to +125 ºC
Case Temperature .................................................. +125 ºC
DC Voltage .......................................................... +18 Volts
Continuous RF Input Power .................................. +13 dBm
Short Term RF Input Power ............. 50 mW (1 Minute Max.)
Maximum Peak Power .................... 0.5 Watt (3 µsec Max.)
Guaranteed @ 25 ºC (160 MHz) Phase Noise Performance (dBc/Hz)*
Frequency
Typical
Guarantee (min.)
100 Hz
- 162
- 158
1 kHz
- 170
- 168
10 kHz
- 172
100 kHz
- 173
1 MHz
- 173
- 170
- 170
- 170
*Note: Phase Noise Performance typically tested at midband.
Bandedge performance may vary.
Typical Performance Data
Gain (dB)
21
Reverse Isolation (dB)
Phase Noise (dBc/Hz)
0
-1 30
-10
-140
20
-20
-30
-15 0
19
Start 10 MHz
Stop 30 0 MHz
1 dB Comp. (dBm)
+2 0
-40
Start 10 MHz
4
Stop 30 0 MHz ^{-16 0}
Noise Figure (dB)
-17 0
+1 9
-18 0
+1 8
3
+1 7
- 19 0
1 00
1k
10 k
10 0k
1M
+1 6
Start 10 MHz
3. 0
Input VSWR
Sto p 3 00 MHz
2
Sta rt 10 MHz
2.0
Output VSWR
Stop 30 0 MHz
Ty pi ca l
*Phase Noise Test Conditions:
Carrier Frequency: 160 mHz
2. 0
1.5
Power Output: +18 dBm
Temperature: 25 ºC
Agilent ES5500 System
1. 0
Start 1 0 MH z
Stop 300 MHz ^1.0 _{Start 10 MHz}
Stop 30 0 MHz
Legend
+25 ºC
+85 ºC - - - - - - -55 ºC
Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH [phone] · Fax [phone]
Rev.
4/22/09
www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pennsylvania 19154 · PH [phone] · Fax [phone]