TM3115PM Datasheet, PDF (1/1 Pages) API Technologies Corp – RF AMPLIFIER MODEL

RF AMPLIFIER
MODEL TM3115PM
Available as: TM3115PM, 4 Pin TO-8 (T4)
TN3115PM, 4 Pin .450” sq. Surface Mount (SM3)
BXF3115PM, SMA Connectorized Housing (H1)
Features
n Low Phase Noise Bipolar Design
n High Output Power: 27 dBm Typical
n Operating Temp. -55 ºC to +85 ºC
n Environmental Screening Available
Specifications
CHARACTERISTIC
Frequency
TYPICAL
Ta= 25 ºC
10 - 1400 MHz
MIN/MAX
Ta = -55 ºC to +85 ºC
10 - 1400 MHz
Gain
13.0 dB
11.5 dB Min.
Power @ 1 dB Comp.
(10-1000 MHz)
(1000-1200 MHz)
(1200-1400 MHz)
27 dBm
24 dBm
22 dBm
25 dBm Min.
22 dBm Min.
20 dBm Min.
Reverse
Isolation (dB)
-17 dB
-
VSWR
In
1.8:1
Out
1.8:1
2.2:1 Max.
2.0:1 Max.
Noise Figure (dB)
8.0 dB
10.0 dB Max.
Typical Intermodulation Performance at 25 º C
Second Order Harmonic Intercept Point ....... +40 dBm (Typ.)
Second Order Two Tone Intercept Point ........ +35 dBm (Typ.)
Third Order Two Tone Intercept Point ............ +30 dBm (Typ.)
Absolute (No Damage) Maximum Ratings
Ambient Operating Temperature ................ -55ºC to +100 ºC
Storage Temperature .................................-62ºC to +125 ºC
Case Temperature .................................................. +125 ºC
DC Voltage .......................................................... +17 Volts
Continuous RF Input Power .................................. +15 dBm
Short Term RF Input Power ..... 50 Milliwatts (1 Minute Max.)
Maximum Peak Power ................... 0.1 Watt (3 µsec Max.)
Guaranteed Phase Noise Performance (dBc/Hz)
Frequency
10 Hz
100 Hz
1 kHz
10 kHz
100 kHz
1 MHz
Typical
-143
-153
-167
-170
-175
-175
Guarantee
-135
-145
-155
-165
-170
-170
Power
Vdc
mA
+15 volts
195 mA
+15 volts
210 mA Max.
Note: Care should always be taken to effectively ground the case of each unit.
(Measured in a 50 Ohm system @ +15 Volts DC nominal unless otherwise noted)
Revision 9-3-2013
Typical Performance Data
Gain (dB)
15
Reverse Isolation (dB)
0
-130
Phase Noise (dBc/Hz)
14
13
12
11
Start 10 MHz
1 dB Comp. (dBm)
+28
+26
-10
-140
-20
-150
-30
Stop
1400 MHz
-40
Start
10
MHz
-160
Stop 1400 MHz
-170
Noise Figure (dB)
10
-180
8
+24
+22
+20
Start 10 MHz
6
4
2
Stop 1400 MHz Start 10 MHz
-19010
100
1k
10k
100k
1M
_______Guarantee __ __ __ Typical
Stop 1400 MHz
Input VSWR
2.0
Output VSWR
2.0
* Residual Phase Noise Test Conditions:
Carrier Frequency: 1280 MHz
Power Output: +24.0 dBm
1.5
1.5
Temperature: 25 ºC
Agilent ES5500 System
1.0
Start 10 MHz
Stop 1400 MHz
1.0
Start
10 MHz
Stop 1400 MHz
Legend
+25 ºC
+85 ºC - - - - - - -55 ºC
www.SpectrumMicrowave.com
Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH [phone] · Fax [phone]
Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pa. 19154 · PH [phone] · Fax [phone]