QBH-1423PM Datasheet, PDF (1/1 Pages) API Technologies Corp – RF AMPLIFIER MODEL

RF AMPLIFIER
MODEL QBH-1423PM
Available as: QBH-1423PM, 4 Pin TO-8 (T4)
QBH-5023PM, 4 Pin Surface Mount (SM3)
QBH-9-1423PM, Connectorized Housing (H1)
Features
! Superior Phase Noise Performance
! Replaces Avantek’s “1023” Design
! Operating Temp. -55 ºC to +85 ºC
! Environmental Screening Available
Specifications
CHARACTERISTIC
Frequency
TYPICAL
Ta= 25 ºC
10 - 1000 MHz
MIN/MAX
Ta = -55 ºC to +85 ºC
10 - 1000 MHz
Gain (dB)
13.0
12.0 Min.
Gain Flatness (dB)
± 0.25
± 0.75 Max.
Power @ 1 dB Comp.
(dBm) _{(10-500 MHz)}
28.0
(500-1000 MHz)
26.5
Reverse
Isolation (dB)
-17
25.5 Min.
25.0 Min.
-15 Max.
VSWR
In
1.5:1
Out
1.5:1
Noise Figure (dB)
6.0
2.0:1 Max.
2.0:1 Max.
9.0 Max.
Power
Vdc
+15
+15
mA
195
210 Max.
Notes: Care should always be taken to effectively ground the case of each unit.
Measured in a 50 Ohm system @ +15 Volts DC nominal unless otherwise noted.
Typical Intermodulation Performance at 25ºC
Second Order Harmonic Intercept Point ....... +46 dBm (Typ.)
Second Order Two Tone Intercept Point ........ +40 dBm (Typ.)
Third Order Two Tone Intercept Point ............ +34 dBm (Typ.)
Absolute Maximum Ratings
Ambient Operating Temperature ................ -55ºC to +100 ºC
Storage Temperature .................................-62ºC to +125 ºC
DC Voltage .......................................................... +17 Volts
Continuous RF Input Power¹ .......................................................... +17 dBm
Short Term RF Input Power¹ ..... 100 Milliwatts (1 Minute Max.)
MTBF Calculation for Ground Benign Environment
@ 25ºC .................................................1,674,483.59 hrs
25ºC Phase Noise Performance in dBc/Hz @ 600 MHz²
Frequency offset
Typical
Guaranteed
10 Hz
-150
-145
100 Hz
-160
-155
1 kHz
-175
-170
10 kHz
-180
-175
100 kHz
-180
-175
1 MHz
-180
-175
1 _{RF output terminated into 50 Ohms.}
2 _{Phase noise performance may vary within the frequency band.}
Gain (dB)
15
Typical Performance Data
Reverse Isolation (dB)
0
-130
Phase Noise (dBc/Hz)
14
13
12
11
Start 10 MHz
1 dB Comp. (dBm)
+29
+28
- 10
-1 40
-20
-150
- 30
- 40
-1 60
Stop 100 0 MHz Start 1 0 MHz
Stop 100 0 MHz
Noise Figure (dB)
-1 70
8
-1 80
7
+27
6
- 1901 ₀
100
1k
10 k
10 0k
1M
+26
5
Typical
+25
4
Start 10 MHz
2.0
1.5
Stop 10 00 MHz Start 10 MHz
Stop 100 0 MHz
Input VSWR
Output VSWR
2.0
1.5
* ^{Residual Phase Noise Test Conditions:}
! Carrier Frequency: 600 MHz
! Power Output: +27.0 dBm
! Temperature: 25 ºC
! Agilent ES5500 System
1.0
Start 10 MHz
1.0
Sto p 1 000 MH z Start 10 MHz
Stop 1000 MHz
Legend
+25 ºC
+85 ºC - - - - - - -55 ºC
Linear S-Parameters Data
FREQ.
– – S11– –
– – S21– –
– – S12– –
– – S22– –
=^M=^H=^z========^M==^ag===^A=ⁿ=^g=========^M=^a=^g===^A=ⁿ=^g========^M=^a=^g===^A=ⁿ=^g=========^M=^a=^g===^A=ⁿ=^g=
10
0.11 -61.9
4.70 -172.3
0.11 8.8
0.23 151.8
250
0.02 -83.6
4.66 116.7
0.11 -34.4
0.14 148.5
500
0.01 -171.7
4.55 54.5
0.12 -70.5
0.14 124.8
750
0.02 126.7
4.49 -7.5
0.13 -109.3
0.15 97.0
1000
0.05 15.7
4.51 -70.8
0.14 -151.2
0.13 40.7
1200
0.12 -44.2
4.58 -123.8
0.15 173.5
0.13 -25.7
1300
0.16 -70.8
4.60 -151.8
0.15 155.1
0.14 -68.5
Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH [phone] · Fax [phone]
Rev.
9/24/09
www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pennsylvania 19154 · PH [phone] · Fax [phone]