DDF3311 Datasheet, PDF (1/6 Pages) API Technologies Corp – PIN Diode Drivers

PIN Diode Drivers
Spectrum Microwave o ffers a complete line-up of PIN diode switch
drivers with output current capability of 10 mA to 50 mA and
switching speeds as fast as 6 ns. Thin film metalization on ceramic
substrates ensures low parasitic capacitance for fast switching, small
size, and excellent reliability. AH FMt drivers are designed by our
experienced engineering staff; thus, if the drivers listed in the
table below do not meet your requirements, we would be happy
to discuss a custom circuit to fit your exact needs.
FEATURES
• M IL-STD-883 Level B Screening available
• Inverting and Non-inverting modes
• Positive and negative output currents
• –55º to +125ºC operating temp range
• –65º to –150ºC storage temp range
M ODEL
DD111/M
DD211/M
DD211B
DD311A
DDF11/M
DDF2311
DDF3311
DDF4311
DDF5311
DDF6311
3
5
1
OUTPUT CURRENT
D.C. (mA)
M INIM UM
M INIM UM
OPEN CK T
2 _MAX
M AXIM UM REP.
SW ITCHING RATE
M AXIM UM
INTERNA L
CURRENT
DRA IN
4
OPERATING VOLTAGE
LIM ITS (V)
MAX
POW ER
DISSIPA -
TION (W )
POSITIVE NEGATIVE ^{PEAK (PA) OUTPUT (V) TIM ES (n s ) (M Hz ) (mA)}
+5V
Vee
100º C 25º C
M IN M A X M IN M A X POS NEG POS NEG To n To ff
+5V V ee M IN M A X M IN M A X ^{CA SE A M B}
1 12/24 18/36 12 18 100 150 2.5 5.5 25 25 5 45 25 4.5 5.5 5 16 0.8 0.5
2 12 18 12 18 100 150 2.5 5.5 25 25 5 90 50 4.5 5.5 5 16 1.6 0.5
2 24 36 12 18 100 150 2.5 5.5 25 25 5 90 50 4.5 5.5 5 16 1.6 0.5
1 8 12 24 36 300 300 4.0 11.0 6 8 20 15 15 4.5 5.5 5 16 0.8 0.5
1 8 12 24 36 300 300 4.0 11.0 12 15 10 45 15 4.5 5.5 5 16 0.8 0.5
2 8 12 24 36 300 300 4.0 11.0 12 15 10 60 30 4.5 5.5 5 16 1.0 0.8
3 8 12 24 36 300 300 4.0 11.0 12 15 10 75 45 4.5 5.5 5 16 1.5 1.2
4 8 12 24 36 300 300 4.0 11.0 12 15 10 90 60 4.5 5.5 5 16 1.9 1.2
5 8 12 24 36 300 300 4.0 11.0 12 15 10 135 75 4.5 5.5 5 16 2.8 1.6
6 8 12 24 36 300 300 4.0 11.0 12 15 10 150 90 4.5 5.5 5 16 3.3 1.6
NOTES:
1. Output current is measured into a 10 Ohm load to ground.
2. Load is a 50 pF (39 + 10 scope probe) capacitor in parallel with a grounded cathode HP5082-0C01 PIN diode.
Ton is measured from 50% of input (from a S<ASOO gate) to 10 +1 V diode load.
Toff is measured from 50% of input to the rated open ckt negative voltage across diode load.
3. Exclusive of current supplied to the load.
4. To avoid exceeding power rating, the max. Vee should be held to 5 V when driving grounded anode diode.
5. De-rate linearity to 175 º C. Temperature is measured at case bottom, which should be heat sunk if necessary.
Specifications subject to change without notice.
165Cedar Hill Street,Marlborough,MA01752 Tel:[phone] Fax: [phone]
www.SpectrumMicrowave.com