CZ8220 Datasheet, PDF (1/1 Pages) Spectrum Microwave, Inc. – RF AMPLIFIER

RF AMPLIFIER
MODEL CZ8220
Available as:
CZ8220, 3 Pin TO-39 (T10)
TN8220, 4 Pin Surface Mount (SM3)
FP8220, 4 Pin Flatpack (FP4)
BX8220, Connectorized Housing (H1)
Features
! Lower Cost; Medium Gain: 10 dB Typical
! Output Power: +8 dBm Typical
! Operating Temp. 0 ºC to +70 ºC
! Environmental ScreeningAvailable
Typical Intermodulation Performance at 25 º C
Second Order Harmonic Intercept Point........+32 dBm (Typ.)
Second Order Two Tone Intercept Point.........+26 dBm (Typ.)
Third Order Two Tone Intercept Point.............+20 dBm (Typ.)
Specifications
CHARACTERISTIC
TYPICAL
Ta= 25 ºC
MIN/MAX
Ta = 0 ºC to +70 ºC
Frequency
kHz - 600 MHz
kHz - 600 MHz
Gain (dB)
10
Power @ 1 dB
Comp. (dBm)
+8
Reverse
Isolation (dB)
-14.5
9.0 Min.
+6.0 Min.
-14 Max.
VSWR
In
Out
Noise figure (dB)
<1.75:1
<1.75:1
<6.0
2.5:1 Max.
2.5:1 Max.
7.5 Max.
Power
Vdc
+3.2
+3.2
mA
25
28 Max.
Note: Care should always be taken to effectively ground the case of each unit.
Maximum Ratings
Ambient Operating Temperature .............. -55ºC to + 125 ºC
Storage Temperature ............................... -62ºC to + 125 ºC
Case Temperature ................................................. + 125 ºC
DC Current ............................................................. 55 mA
Continuous RF Input Power ................................. + 13 dBm
Short Term RF Input Power ...... 50 Milliwatts (1 Minute Max.)
Maximum Peak Power .................... 0.5 Watt (3 µsec Max.)
Typical Performance Data
12
11
10
9
8
Start kHz
Gain (dB)
Stop 600 MHz
1 dB Comp. (dBm)
+10
+9
+8
+7
+6
Start kHz
Stop 600 MHz
Reverse Isolation (dB)
0
- 10
- 20
- 30
- 40
Start kHz
Stop 600 MHz
Input VSWR
2.0
1.5
1.0
Start kHz
Stop 600 MHz
8
7
6
5
4
Start kHz
2.0
1.5
1.0
Start kHz
Noise Figure (dB)
Stop 600 MHz
Output VSWR
Stop 600 MHz
Legend
+25 ºC
+70 ºC - - - - - - 0 ºC
The CZ82X0 Series Amplifiers are designed for application in 50 ohm
systems. Three external capacitors and a decoupling impedance are
required. The decoupling impedance must be large in comparison to
the 50 ohm load to minimize gain reduction. Data sheet curves are
based on the noted decoupling impedance. The external capacitors
determine the low frequency recponse of the Amplifier.
The CZ82X0 Series Amplifiers can be cascaded in series of two or
more units without oscillation problems.
* Decoupling Impedance is 1 KOhm
Schematic Diagram
+Vcc
50 Ohm Input
CZ SeriesAmp _Decoupling
Impedance
50 Ohm Output
Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH [phone] · Fax [phone]/04
www.SpectrumMicrowave.com Spectrum Microwave (Europe) · 2707 Black Lake Place · Philadelphia, Pa. 19154 · PH [phone] · Fax [phone]