QBS-610 Datasheet, PDF (1/2 Pages) API Delevan – RF Adjustable AGC/Limiting Line Amplifier L-Band 1.0 - 2.0 GHz

Model: QBS-610
RF Adjustable AGC/Limiting Line Amplifier
L-Band 1.0 - 2.0 GHz
Features
• Adjustable Small-Signal Gain, AGC Output Threshold, Minimum Gain, and
Maximum Output Power
• Uses GaAs MESFET and E-pHEMT Technologies
• Variable AGC and Limiting Module
• Class A Output Stage
• Microprocessor Based Control Loop
API Technologies’ Model QBS-610 is an automatic gain control/limiting line amplifier module covering 1-2 GHz. This
design provides variable small-signal gain, AGC output power threshold, minimum gain, and maximum output power
settings. The QBS-610 allows for adjustment, via mechanical set screw, of four key operating parameters to allow for
ease of integration and system alignment.
Technical Specifications
Parameter
Specifications ⁽¹⁾
Frequency
Input Power
Output Limiter Power
Small-Signal Gain
AGC Output Threshold
Minimum Gain (AGC Enabled)
Reverse Isolation
Gain Flatness
Linear Phase Deviation
Noise Figure
Output P1dB
Output IP3
Input / Output Impedance
Input / Output VSWR
DC Input Voltage
DC Input Power
1.0 – 2.0 GHz
-80 to -20 dBm
+8 to +20 dBm
40 to 48 dB
-11 to -3 dBm
18 to 26 dB
60 dB (min)
1.8 dB pk-pk (max)
±7.0 degrees (max)
6.5 dB (max)
+19.0 dBm (min)
+29.0 dBm (min)
50 Ω
1.3 : 1 (max)
+24 to +32 VDC
17 W (max)
Comments
Note 2
Note 3
Notes 3, 4
Notes 3, 5
Notes 3, 6
Note 7
Note 8
Note 9
Note 9
Note 9
Nominal
Note 10
General
Control / Interface
Signals
MTBF
AGC Bypass → TTL Logic
Summary Fault Indicator → Open-Collector⁽¹¹⁾
200,000 hrs.
+50⁰C Ground Fixed Environment
MIL-HDBK-217F
Mechanical
Case Dimensions
Material
Finish
Weight
Grounding
Outline Drawing
Connectors
RF Input
RF Output
DC Power
Environmental
Parameter
Operating Case
Temperature
Absolute Maximum
Case Temperature
Storage Temperature
Cooling
Relative Humidity
Altitude
5.0” (L) x 3.0” (W) x 1.2” (H)
6061-T6 Aluminum Alloy
Clear Iridite
MIL-DTL-5541F Type II, Class 3
16 oz. (max)
Chassis
080-23035
N-Type Female (4-Hole Flange)
N-Type Female (4-Hole Flange)
9 Pin D-Sub (Male)
Standard Density
Specification
-40⁰C to +70⁰C
Comments
-
+90⁰C
-
-55⁰C to +125⁰C
Adequate Heat
Sink Required
0 to 90%
0 to 10,000 ft.
-
Conduction
Non-condensing
Above Sea Level
Rev Date: 8/26/2014
Page #1
© API Technologies Corp. Proprietary Information | www.apitech.com | micro.apitech.com | +1.888.553.7531 |
[e-mail]