APL5611 Datasheet, PDF (2/16 Pages) Anpec Electronics Coropration – Low Dropout Linear Regulator Controller

APL5611/A
Ordering and Marking Information
APL5611
APL5611A
Assembly Material
Handling Code
Temperature Range
Package Code
Package Code
C : SOT-23-6
Operating Ambient Temperature Range
I : -40 to 85 ^oC
Handling Code
TR : Tape & Reel
Assembly Material
G : Halogen and Lead Free Device
APL5611 C:
L11X
X - Date Code
APL5611A C:
LA1X
X - Date Code
Note: ANPEC lead-free products contain molding compounds/die attach materials and 100% matte tin plate termination finish; which
are fully compliant with RoHS. ANPEC lead-free products meet or exceed the lead-free requirements of IPC/JEDEC J-STD-020D for
MSL classification at lead-free peak reflow temperature. ANPEC defines “Green” to mean lead-free (RoHS compliant) and halogen
free (Br or Cl does not exceed 900ppm by weight in homogeneous material and total of Br and Cl does not exceed 1500ppm by
weight).
Absolute Maximum Ratings (Note 1 )
Symbol
Parameter
Rating
Unit
VCC
VCC Input Voltage (VCC to GND)
-0.3 to 15
V
EN, SS, to GND Voltage
-0.3 to 7
V
VFB
FB to GND Voltage
-0.3 to 7
V
VDRV
TJ
TSTG
TSDR
DRV to GND Voltage
Maximum Junction Temperature
Storage Temperature
Maximum Lead Soldering Temperature, 10 Seconds
-0.3 to VCC+0.3
V
150
o_C
-65 to 150
o_C
260
o_C
Note 1: Absolute Maximum Ratings are those values beyond which the life of a device may be impaired. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability.
Thermal Characteristic
Symbol
θJA
Parameter
Junction-to-Ambient Resistance in Free Air ^{(Note 2)}
SOT-23-6
Typical Value
250
Note 2: θJA is measured with the component mounted on a high effective thermal conductivity test board in free air.
Unit
o_C/W
Recommended Operating Conditions (Note 3)
Symbol
Parameter
Range
Unit
VCC
VCC Input Voltage (VCC to GND)
4.5 to 13.5
V
VEN
VOUT
TA
TJ
EN to GND Voltage
VOUT Output Voltage ^(Note4)
Ambient Temperature
Junction Temperature
0 to 5.5
V
0.8 ~ VIN - VDROP
V
-40 to 85
o_C
-40 to 125
o_C
Note 3: Refer to the typical application circuit.
Note 4: VDROP defined as the VIN -VOUT voltage at VOUT = 98% normal VOUT. The linear regulator must provide the output MOSFET with
sufficient Gate-to-Source voltage (VGS = VCC - VOUT) to regulate the output voltage.
Copyright © ANPEC Electronics Corp.
2
Rev. A.5 - Oct., 2012
www.anpec.com.tw