T0727J5012AHF Datasheet, PDF (4/6 Pages) Anaren Microwave – Designed for LTE applications

Model T0727J5012AHF
Rev B
Mounting Configuration 50 Ohm to 12.5 Ohm:
In order for Xinger surface mount components to work optimally, the proper impedance transmission lines must be
used to connect to the RF ports. If this condition is not satisfied, insertion loss, Isolation and VSWR may not meet
published specifications.
All of the Xinger components are constructed from organic PTFE based composites which possess excellent
electrical and mechanical stability. Xinger components are compliant to a variety of ROHS and Green standards and
ready for Pb-free soldering processes. Pads are Gold plated with a Nickel barrier.
Series capacitor C1 at pin1 and shunt capacitor C2 at pin4 are required to get the optimum performance.
All the input and output pins are DC connected internally together with RF grounds pins. DC bias can be applied
through appropriate RF choke and DC blocking capacitor.
An example of the PCB footprint used in the testing of these parts is shown below. In specific designs, the
transmission line widths need to be adjusted to the unique dielectric coefficients and thicknesses as well as varying
pick and place equipment tolerances.
Plated thru
holes to
ground
6X .012
[0.30]
6X .010
[0.25]
6X .002
[0.05]
C2
3X Transmission
Line
C1
.033
[0.85]
Part Orientation (Top View)
4X .014
[0.35]
Visit us at
www.Anaren.com
USA/Canada:
Toll Free:
Europe:
Asia:
[phone]
[phone]
[phone]
[phone]