PD3150J5050S2 Datasheet, PDF (4/6 Pages) Anaren Microwave – Ultra Low Profile 0805 Power Divider 50Ω to 50Ω

Model PD3150J5050S2
Rev C
Mounting Configuration:
In order for Xinger surface mount components to work optimally, the proper impedance transmission lines must be
used to connect to the RF ports. If this condition is not satisfied, insertion loss, Isolation and VSWR may not meet
published specifications.
An example of the PCB footprint used in the testing of these parts is shown below. In specific designs, the
transmission line widths need to be adjusted to the unique dielectric coefficients and thicknesses as well as varying
pick and place equipment tolerances. In addition, since the PD3150J5050S2 is a Wilkinson power divider, an
external 0603 150Ω resistor must be mounted in locations R1 as shown in the Figure below.
All of the Xinger components are constructed from ceramic filled PTFE composites which possess excellent electrical
and mechanical stability having X and Y thermal coefficient of expansion (CTE) of 17 ppm/^oC.
Pad Footprint w/ 0603 Resistor Locations
6X .014
[0.35]
4X .012
[0.30]
6X .010
[0.25]
6X .002
[0.05]
R1
Circuit Pattern
Footprint Pad (s)
Solder Resist
Dimensions are in Inches [Millimeters]
Mounting Footprint
.033
[0.85]
Plated thru
holes to
ground
3X Transmission
Line
USA/Canada:
Toll Free:
Europe:
[phone]
[phone]
[phone]
Available on Tape and
Reel for Pick and Place
Manufacturing.