100200-4Z50-2 Datasheet, PDF (2/2 Pages) Anaren Microwave – Surface Mount Termination 10 Watts, 50W

Model 100200-4Z50-2
Typical Performance:
Power De-rating:
Tape & Reel:
PCB Solder interface Temperature - °C
Mounting Footprint and Procedure:
50 ohm line
0.092 [2.34]
0.025 [0.63]
0.035 [0.89]
Ø0.101 [Ø2.57]
2x 4-40 Screw Hole
Ø0.031 [Ø0.79]
0.060 [1.52]
0.250 [6.35]
Dimension given in inches [millimeters]
For best thermal performance the PCB should be soldered to
the heat sink.
USA/Canada:
Toll Free:
Europe:
[phone]
[phone]
[phone]
Available on Tape and
Reel For Pick and Place
Manufacturing.
SCREW
(2 PLS.)
SOLDER
PASTE
PC BOARD
HEATSINK
MOUNTING PROCEDURE
SOLDER
FILLED VIA
1. Drill thermal vias through PCB and fill with solder.
2. Solder part in place using appropriate solder with a controlled temperature iron.
3. To ensure good thermal connectivity to heat sink, which is critical for proper
operation, drill and tap heatsink and mount PCB board to heatsink using screws.
100200-4Z50-2 (097) Rev B pg. 2 of 2