RFP-100200A25Z50 Datasheet, PDF (1/2 Pages) Anaren Microwave – Surface Mount Termination 10 Watts, 50ohm

Features:
• 10 Watts
• Lowest Cost
• True Surface Mount
• Alumina Ceramic
• Non-Nichrome Resistive
Element
• Low VSWR
• 100% Tested
Outline Drawing
Model RFP-100200A25Z50
Surface Mount
Termination
10 Watts, 50Ω
Description
The RFP-100200A25Z50 is high performance Alumina surface mount
termination intended as a lower cost alternative to Aluminum Nitride (AlN)
and Beryllium Oxide (BeO). The termination is well suited to all cellular
frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The
high power handling makes the part ideal for terminating 90 degree
hybrid, directional couplers, and for use in isolators.
General Specifications
Resistive Element
Thick film
Substrate
Alumina Ceramic
Terminal Finish
Thick film Silver
Operating Temperature -55 to +125°C (see chart)
Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed
applicable portions of MIL-E-5400. All dimensions in inches.
Electrical Specifications
Resistance Value:
50 ohms, ± 2%
Power:
10 Watts
Frequency Range:
DC – 3.0 GHz
V.S.W.R.:
<1.25:1
Specification based on unit properly installed using suggested mounting instructions
and a 50 ohm nominal impedance. Specifications subject to change without notice
100200A25Z50 (097) Rev C
Available on Tape
and Reel For Pick and
Place Manufacturing.
USA/Canada:
Toll Free:
Europe:
[phone]
[phone]
[phone]