PD0922J5075D2 Datasheet, PDF (1/6 Pages) Anaren Microwave – Ultra Low Profile 0805 Power Divider 50Ω to 75Ω

Model PD0922J5075D2
Rev D
Ultra Low Profile 0805 Power Divider
50Ω to 75Ω
Description
The PD0922J5075D2 is a low profile, sub-miniature Wilkinson power divider in an
easy to use surface mount package and is ideal for high volume manufacturing
while delivering higher performances than traditional printed and lumped element
solutions. It has been designed for the following markets: DVB-S, GSM, DCS, PCS,
WCDMA, GPS, 802.11a+g, Bluetooth, and Zigbee USA.
The PD0922J5075D2 is matched to 50Ω at the input and 75Ω at the outputs and
has a height profile of 0.8 mm. A two section Wilkinson design results in increased
isolation performance. Two external resistors are required for operation.
Components are available on tape and reel for high volume manufacturing pick and
place.
All Xinger components are constructed from ceramic filled PTFE composites which
possess excellent electrical and mechanical stability having X and Y thermal
coefficient of expansion (CTE) of 17 ppm/^oC.
Detailed Electrical Specifications: Specifications subject to change without notice.
ROOM (25°C)
Features:
• 950 – 2150 MHz
• 14 dB Isolation (output ports)
• Good Return Loss
• 0.8mm Height Profile
• 50Ω Input/ 75Ω Output
Parameter
Frequency
Input Port Impedance
Output Port Impedance
Return Loss
Min.
950
11
Typ.
50
75
13
Max
2150
Unit
MHz
Ω
Ω
dB
• External resistors required
• Low Insertion Loss
• Surface Mountable
• Tape & Reel
• Non-conductive Surface
• RoHS Compliant
Insertion Loss*
Amplitude Balance
Phase Balance
Isolation (Output Ports)
Power Handling
0.5
0.7
dB
0.1
0.3
dB
1
3
Degrees
12
14
dB
2
Watts
Operating Temperature
-55
* Insertion Loss stated at room temperature (Insertion Loss is approximately 0.1 dB higher at +85 ºC)
Outline Drawing
+85
ºC
Top View (Near-side)
Side View
Bottom View (Far-side)
.079±.004
[2.00±0.10]
.021±.002
[0.53±0.05]
.049±.004
[1.25±0.10]
Orientation
Marker Denotes
Pin Location
Dimensions are in Inches [Millimeters]
Mechanical Outline
Pin Designation
1 Mid 1
2 Input
3 Mid 2
4 Output 1
5 GND
6 Output 2
.039
[0.98]
12
Orientation
Marker Denotes
Pin Location
65
6X .012
[0.30]
4X .026
[0.65]
3
6X .009
[0.22]
4
Tolerances are Non-Cumulative
Available on Tape
and Reel for Pick and
Place Manufacturing.
USA/Canada:
Toll Free:
Europe:
[phone]
[phone]
[phone]