I100N50X4 Datasheet, PDF (1/2 Pages) Anaren Microwave – Flange Mount Termination 100 Watts, 50Ω

Features:
• RoHS Compliant
• 100 Watts
• DC – 3.0 GHz
• AlN Ceramic
• Non-Nichrome Resistive
Element
• Low VSWR
• 100% Tested
Outline Drawing
ROHS
Compliant
Description
Model I100N50X4
Flange Mount Termination
100 Watts, 50Ω
The I100N50X4 is high performance Aluminum Nitride (AlN) flange mount
termination intended as a cost competitive alternative to Beryllium Oxide
(BeO). The termination is well suited to all cellular frequency bands such
as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling
makes the part ideal for terminating circulators, and for use in power
combiners. The termination is also RoHS compliant!
General Specifications
Resistive Element
Thick Film
Substrate
AlN Ceramic
Cover
Alumina Ceramic
Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed
applicable portions of MIL-E-5400. All dimensions in inches.
Electrical Specifications
Resistance Value:
50 Ohms, ± 2%
Power:
100 Watts
Frequency Range:
DC – 3.0GHz
V.S.W.R.
1.25 : 1
Specification based on unit properly installed using suggested mounting instructions
and a 50 ohm nominal impedance. Storage temperature is -20°C to 85 ºC . Operating
temperature is -55ºC to 125ºC (see chart for derating temperatures). Specifications
subject to change with out notice.
Note: All dimensions in inches – 1inch = 2.54cm. Lead Length: 0.150in min.
USA/Canada:
Toll Free:
Europe:
I100N50X4 (097) Rev D.
[phone]
[phone]
[phone]