C10A50Z4 Datasheet, PDF (1/2 Pages) Anaren Microwave – Surface Mount Termination

Features:
• 10 Watts
• Lowest Cost
• RoHS Compliant
• Alumina Ceramic
• Non-Nichrome Resistive
Element
• Low VSWR
• 100% Tested
Outline Drawing
Model C10A50Z4
Surface Mount Termination
10 Watts, 50Ω
Description
The C10A50Z4 is high performance RoHS compliant Alumina (Al₂O₃)
surface mount termination intended as a lower cost alternative to
Aluminum Nitride (AlN) and Beryllium Oxide (BeO). The termination is
well suited to all cellular frequency bands such as; AMPS, GSM, DCS,
PCS, PHS and UMTS. The high power handling makes the part ideal for
terminating 90 degree hybrid directional couplers, and for use in isolators.
General Specifications
Resistive Element
Thick film
Substrate
Alumina Ceramic
Terminal Finish
Matte Tin over Nickel
Operating Temperature -55 to +125°C (see chart)
Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed
applicable portions of MIL-E-5400. All dimensions in inches.
Electrical Specifications
Resistance Value:
50 ohms, ± 2%
Power:
10 Watts
Frequency Range:
DC – 3.0 GHz
V.S.W.R.:
<1.25:1
Specification based on unit properly installed using suggested mounting instructions
and a 50 ohm nominal impedance. Specifications subject to change without notice
All dimensions in inches.
07/26/2006 Rev. B
Available on Tape
and Reel For Pick and
Place Manufacturing.
USA/Canada:
Toll Free:
Europe:
[phone]
[phone]
[phone]