BD0810J50200A00 Datasheet, PDF (1/6 Pages) Anaren Microwave – Ultra Low Profile 0805 Balun 50Ω to 200Ω Balanced

Model BD0810J50200A00
Rev B
Ultra Low Profile 0805 Balun
50Ω to 200Ω Balanced
Description
The BD0810J50200A00 is a low profile sub-miniature balanced to unbalanced
transformer designed for differential inputs and output locations on next generation
wireless chipsets in an easy to use surface mount package covering the GSM
frequency. The BD0810J50200A00 is ideal for high volume manufacturing and is
higher performance than traditional ceramic and lumped element baluns. The
BD0810J50200A00 has an unbalanced port impedance of 50Ω and a 100Ω
balanced port impedance. This transformation enables single ended signals to be
applied to differential ports on modern semiconductors. The output ports have equal
amplitude (-3dB) with 180 degree phase differential. The BD0810J50200A00 is
available on tape and reel for pick and place high volume manufacturing.
Detailed Electrical Specifications: Specifications subject to change without notice.
ROOM (25°C)
Features:
• 800 – 1000 MHz
• 0.7mm Height Profile
• 50 Ohm to 2 x 100 Ohm
• GSM
• Low Insertion Loss
• Input to Output DC Isolation
• Surface Mountable
• Tape & Reel
• Non-conductive Surface
• RoHS Compliant
Parameter
Frequency
Unbalanced Port Impedance
Balanced Port Impedance
Return Loss
Insertion Loss*
Amplitude Balance
Phase Balance
CMRR
Power Handling
Min.
800
14.5
Typ.
50
200
19
0.7
0.6
5
26
Max
1000
1.0
1.1
8
2
Operating Temperature
-55
+85
* Insertion Loss stated at room temperature (Insertion Loss is approximately 0.1 dB higher at +85 ºC)
Outline Drawing
Top View (Near-side)
Side View
Bottom View (Far-side)
Unit
MHz
Ω
Ω
dB
dB
dB
Degrees
dB
Watts
ºC
.079±.004
[2.00±0.10]
.027±.002
[0.70±0.05]
.049±.004
[1.25±0.10]
.039 [0.98]
12
.026 [0.65]
3
6X .009
[0.22]
Orientation
Marker Denotes
Pin Location
Dimensions are in Inches [Millimeters]
Mechanical Outline
Orientation
Marker Denotes 6 5
4
Pin Designation
Pin Location
1 Unbalanced Port
6X .012
[0.30]
2 GND / DC Feed
+ RF GND
3 Balanced Port
4 Balanced Port
5 GND
6 NC
Tolerances are Non-Cumulative
Available on Tape
and Reel for Pick and
Place Manufacturing.
USA/Canada:
Toll Free:
Europe:
[phone]
[phone]
[phone]