B0922J7575A00 Datasheet, PDF (1/5 Pages) Anaren Microwave – Ultra Low Profile 0805 Balun 75Ω to 75Ω Balanced

Model B0922J7575A00
Rev C
Ultra Low Profile 0805 Balun
75Ω to 75Ω Balanced
Description
The B0922J7575A00 is a low cost, low profile sub-miniature unbalanced to
balanced transformer designed for differential inputs and output locations on modern
chipsets in an easy to use surface mount package covering dual polarized
commercial Satellite bands 950 MHz –1450 MHz & 1650 MHz – 2150 MHz. The
B0922J7575A00 is ideal for high volume manufacturing and delivers higher
performance than traditional wire wound baluns. The B0922J7575A00 has an
unbalanced port impedance of 75Ω and a 75Ω balanced port impedance*. This
transformation enables single ended signals to be applied to differential ports on
modern integrated chipsets. The output ports have equal amplitude (-3dB) with 180
degree phase differential. The B0922J7575A00 is available on tape and reel for pick
and place high volume manufacturing.
Detailed Electrical Specifications: Specifications subject to change without notice.
ROOM (25°C)
Features:
• 950 – 2150 MHz
• 0.7mm Height Profile
• 75 Ohm to 2 x 37.5 Ohm
• Low Insertion Loss
• Sat LNB Chipset Compliant
• Input to Output DC Isolation
• Surface Mountable
• Tape & Reel
• Non-conductive Surface
• RoHS Compliant
Parameter
Frequency
Unbalanced Port Impedance
Balanced Port Impedance
Return Loss
Insertion Loss*
Amplitude Balance
Phase Balance
CMRR
Power Handling
Min.
950
7.9
Typ.
75
75
9.6
0.8
0.4
3
26
Max
2150
1.2
1.4
9
2
Operating Temperature
-55
+85
* Insertion Loss stated at room temperature (Insertion Loss is approximately 0.1 dB higher at +85 ºC)
Outline Drawing
Top View (Near-side)
Side View
Bottom View (Far-side)
Unit
MHz
Ω
Ω
dB
dB
dB
Degrees
dB
Watts
ºC
.079±.004
[2.00±0.10]
.027±.002
[0.70±0.05]
.049±.004
[1.25±0.10]
.039 [0.98]
12
.026 [0.65]
3
6X .009
[0.22]
Orientation
Marker Denotes
Pin Location
Dimensions are in Inches [Millimeters]
Mechanical Outline
Orientation
Marker Denotes 6 5
4
Pin Location _{6X .012}
Pin Designation
[0.30]
1 GND
2 Unbalanced Port
3 GND
4 Balanced Port
5 NC
6 Balanced Port
Tolerances are Non-Cumulative
Available on Tape
and Reel for Pick and
Place Manufacturing.
USA/Canada:
Toll Free:
Europe:
[phone]
[phone]
[phone]