 English |
|
|
|
|
|
|
|
| AAT3193 Datasheet, PDF (2/18 Pages) Advanced Analogic Technologies – 3-Channel Charge-Pump LED Driver | |||
| |||
| ◁ |
ChargePumpTM
PRODUCT DATASHEET
AAT3193
3-Channel Charge-Pump LED Driver
Pin Descriptions
Pin
1
2
3
4
5
6
7
8
9
10
Symbol
D1
OUT
C-
C+
IN
EN/SET
(AAT3193-1/-2/-3)
EN/PWM
(AAT3193-4)
RSET
GND
D3
D2
Description
LED1 current sink input. D1 is the input of LED1 current sink. Connect LED1âs anode to OUT and its
cathode to D1.
Charge pump output. OUT is the output of the charge pump. Bypass OUT to GND with a 1μF or
larger ceramic capacitor.
Charge pump capacitor negative node.
Charge pump capacitor positive node. Connect a 1μF ceramic capacitor between C+ and C-.
Power source input. Connect IN to the power source, typically the battery. Bypass IN to GND with a
1μF or larger ceramic capacitor.
LED enable and serial control input. EN/SET is the ON/OFF control for the LED and the S2Cwire digital
input for the AAT3193-1/-2/-3 to control serially the LED brightness according to the maximum cur-
rent set by RSET.
LED ON/OFF and PWM control input. This logic input controls the LED outputs for the AAT3193-4.
Alternatively, a PWM signal from a GPIO or an equivalent signal from a separate controller can be
used to control LED output current linearly. A PWM signal, ranging from 10% to 100% duty cycle,
controls the LED current linearly between ZS and FS.
A 1% tolerance resistor from this pin to GND sets the maximum LED current level. For optimal LED
output current accuracy and matching in the AAT3193-1/-2/-4, a 14.3kΩ resistor sets each full-scale
output current to 20mA, maximum. For the AAT3193-3, a 11.5kΩ resistor is recommended.
Ground. Connect this pin to the systemâs ground plane.
LED3 Current Sink Input. D3 is the input of LED3 current sink. Connect LED3âs anode to OUT and its
cathode to D3.
LED2 Current Sink Input. D2 is the input of LED2 current sink. Connect LED2âs anode to OUT and its
cathode to D2.
Pin Configuration
SC70JW-10
(Top View)
D1 1
OUT 2
C- 3
C+ 4
IN 5
10 D2
9 D3
8 GND
7 RSET
6 EN/SET
2
www.analogictech.com
3193.2008.07.1.3
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese