AAT3201 Datasheet, PDF (12/14 Pages) Advanced Analogic Technologies – 150mA OmniPower LDO Linear Regulator

AAT3201
150mA OmniPower™ LDO Linear Regulator
Device Duty Cycle vs. V_DROP
V_OUT = 2.5V @ 25 degrees C
3.5
3
2.5
2
1.5
1
0.5
0
0
10
20
30
40
50
60 70
Duty Cycle (%)
200mA
80 90 100
Device Duty Cycle vs. V_DROP
V_OUT = 2.5V @ 50 degrees C
3.5
3
2.5
200mA
2
150mA
1.5
1
0.5
0
0 10 20 30 40 50 60 70 80 90 100
Duty Cycle (%)
Device Duty Cycle vs. V_DROP
V_OUT = 2.5V @ 85 degrees C
3.5
3
100mA
2.5
2
200mA
1.5
1
150mA
0.5
0
0 10 20 30 40 50 60 70 80 90 100
Duty Cycle (%)
High Peak Output Current Applications
Some applications require the LDO regulator to
operate at continuous nominal levels with short
duration high current peaks. The duty cycles for
both output current levels must be taken into
account. To do so, one would first need to calcu-
late the power dissipation at the nominal continu-
ous level, then factor in the addition power dissipa-
tion due to the short duration high current peaks.
For example, a 2.5V system using a AAT3221/
2IGV-2.5-T1 operates at a continuous 100mA load
current level and has short 150mA current peaks.
The current peak occurs for 378µs out of a 4.61ms
period. It will be assumed the input voltage is 5.0V.
First, the current duty cycle percentage must be
calculated:
% Peak Duty Cycle: X/100 = 378ms/4.61ms
% Peak Duty Cycle = 8.2%
The LDO Regulator will be under the 100mA load
for 91.8% of the 4.61ms period and have 150mA
peaks occurring for 8.2% of the time. Next, the
continuous nominal power dissipation for the
100mA load should be determined then multiplied
by the duty cycle to conclude the actual power dis-
sipation over time.
P_D(MAX) = (V_IN - V_OUT)I_OUT + (V_IN x I_GND)
P_D(100mA) = (5.0V - 2.5V)100mA + (5.0V x 20µA)
P_D(100mA) = 250mW
P_D(91.8%D/C) = %DC x P_D(100mA)
P_D(91.8%D/C) = 0.918 x 250mW
P_D(91.8%D/C) = 229.5mW
12
3201.2002.3.0.91