AAT1351 Datasheet, PDF (12/16 Pages) Advanced Analogic Technologies – 2-CHANNEL SWITCHING REGULATOR

Advanced Analog Technology, Inc.
PACKAGE DIMENSION (CONT.)
AAT1351
SYMBOLS
A
A1
A2
b
C
D
E
E1
e
L
y
θ
DIMENSIONS IN MILLIMETERS
MIN
TYP
MAX
1.47
1.60
1.73
0.10
------
0.25
------
1.45
------
0.33
0.41
0.51
0.19
0.20
0.25
9.80
9.91
10.01
5.79
5.99
6.20
3.81
3.91
3.99
------
1.27
------
0.38
0.71
1.27
------
0^o
------
------
0.076
8^o
DEMINSIONS IN INCHES
MIN TYP MAX
0.058 0.063 0.068
0.004 ------ 0.010
------ 0.057 ------
0.013 0.016 0.020
0.0075 0.0080 0.0098
0.386 0.390 0.394
0.228 0.236 0.244
0.150 0.154 0.157
------ 0.050 ------
0.015 0.028 0.050
------
0^o
-----
------
0.003
8^o
NOTE:
1. CONTROLLING DIMENSION: INCH
2. LEAD FRAME MATERIAL: COPPER 194
3. DIMENSION “D” DOES NOT INCLUDE MOLD FLASH, TIE BAR BURRS AND GATE BURRS. MOLD FLASH, TIE
BAR BURRS AND GATE BURRS SHALL NOT EXCEED 0.006” [0.15 MILLIMETERS] PER END DIMENSION “E1” DOES
NOT INCLUDE INTERLEAD FLASH. INTERLEAD FLASH SAHLL NOT EXCEED 0.010” [0.25 MILLIMETERS] PER
SIDE.
4. DIMENSION “b” DOES NOT INCLUDE DAMBAR PROTRUSION. ALLOWABLE DAMBAR PROTRUSION SHALL BE
0.003” [0.08 MILLIMETERS] TOTAL IN EXCESS OF THE “b” DIMENSION AT MAXIMUM MATERIAL CONDITION.
DAMBAR CANNOT BE LOCATED ON THE LOWER RADIUS OR THE FOOT. MINIMUM SPACE BETWEEN
PROTRUSION AND AN ADJACENT LEAD TO BE 0.0028” [0.07 MILLIMETERS].
5. TOLERANCE: ± 0.010” [0.25 MILLIMETERS] UNLESS OTHERWISE SPECIFIED.
6. OTHERWISE DIMENSION FOLLOW ACCEPTABLE SPEC.
7. REFERENCE DOCUMENT: JEDEC SPEC MS-012
–
–
– Advanced Analog Technology, Inc. –
Page 12 of 16
V1.0