AAT1100 Datasheet, PDF (12/15 Pages) Advanced Analogic Technologies – TRIPLE-CHANNEL PWM CONTROLLER

Advanced Analog Technology, Inc.
Package Dimension (Cont.)
AAT1100
SYMBOLS
A
A1
A2
b
C
D
E
E1
e
L
y
θ
DIMENSIONS IN MILLIMETERS
MIN
TYP
MAX
1.05
1.10
1.20
0.05
0.10
0.15
------
1.00
1.05
0.20
0.25
0.28
------
0.127
------
4.900
5.075
5.100
6.20
6.40
6.60
4.30
4.40
4.50
------
0.65
------
0.50
0.60
0.70
------
------
0.076
0^o
4^o
8^o
DEMINSIONS IN INCHES
MIN TYP MAX
0.041 0.043 0.047
0.002 0.004 0.006
------ 0.039 0.041
0.008 0.010 0.011
------ 0.005 ------
0.1930 0.1998 0.2000
0.244 0.252 0.260
0.170 0.173 0.177
------ 0.026 ------
0.020 0.024 0.028
------ ------ 0.003
0^o
4^o
8^o
NOTE:
1. CONTROLLING DIMENSION: MILLIMETERS
2. LEAD FRAME MATERIAL: OLIN C7025/EFTEC 64T
3. DIMENSION “D” DOES NOT INCLUDE MOLD FLASH, TIE BAR BURRS AND GATE BURRS. MOLD
FLASH, TIE BAR BURRS AND GATE BURRS SHALL NOT EXCEED 0.006” [0.15 MILLIMETERS] PER END.
DIMENSION “E1” DOES NOT INCLUDE INTERLEAD FLASH. INTERLEAD FLASH SHALL NOT EXCEED
0.010” [0.25 MILLIMETERS] PER SIDE.
4. DIMENSION “b” DOES NOT INCLUDE DAMBAR PROTRUSION. ALLOWABLE DAMBAR PROTRUSION
SHALL BE 0.003” [0.08 MILLIMETERS] TOTAL IN EXCESS OF THE “b” DIMENSION AT MAXIMUM
MATERIAL CONDITION. DAMBAR CANNOT BE LOCATED ON THE LOWER RADIUS OR THE FOOT.
MINIMUM SPACE BETWEEN PROTRUSION AND AN ADJACENT LEAD TO BE 0.0028” [0.07
MILLIMETERS].
5. TOLERANCE: ± 0.010 [0.25 MILLIMETERS] UNLESS OTHERWISE SPECIFIED.
6. OTHERWISE DIMENSION FOLLOW ACCEPTABLE SPEC.
7. REFERENCE DOCUMENT: JEDEC SPEC MO-153.
–
–
– Advanced Analog Technology, Inc. –
Page 12 of 15
V 1.0