AAT3172 Datasheet, PDF (1/14 Pages) Advanced Analogic Technologies – High Current LED Flash Driver Charge Pump IC

AAT3172
High Current LED Flash Driver Charge Pump IC
General Description
The AAT3172 is a high output current, high effi-
ciency, low noise, low profile charge pump DC/DC
converter, ideal for multi-function LED photo-flash
applications where solution cost, size, and efficien-
cy are critical.
The dual charge pump in the AAT3172 is capable
of delivering 600mA peak output current. Two cur-
rent-controlled paths are available for users of dual
flash LEDs that prefer current matching. Each LED
channel can be easily programmed in 32 steps with
a single GPIO output through the AS²Cwire™
(Advanced Simple Serial Control™) interface. This
allows smooth transitions and flexible adjustment
of brightness in flash or other lighting modes.
The tri-mode (1X/1.5X/2X) operation of the internal
charge pump offers excellent power efficiency for
both flash and movie modes. Combined with a low
external parts count (two 1µF flying capacitors and
one small bypass capacitor at V_IN and OUT), the
AAT3172 is ideally suited for small, battery-powered
applications.
The AAT3172 has a thermal management system to
protect the device in the event of a short-circuit con-
dition at the output pin. Built-in soft-start circuitry
prevents excessive inrush current during start-up.
The shutdown feature disconnects the load from V_IN
and reduces quiescent current to less than 1.0µA.
The AAT3172 is available in the Pb-free, thermally-
enhanced, 12-pin 3x3 TDFN package.
Features
ChargePump^™
• V_IN Range: 2.7V to 5.5V
• 600mA Peak Output Current
• Tri-Mode 1X/1.5X/2X in Current Mode
• Voltage Mode Operation: 1.5X, 100mA
• Dual Regulated Current Sinks
• Current Match Between Current Sinks
• 32 Current Steps Set by AS²Cwire
• 1µF Input, Output, and Flying Capacitors
• <1.0µA of Shutdown
• Small Application Circuit
• No Inductors
• Automatic Soft Start
• 12-Pin TDFN 3x3 Package
• -40°C to +85°C Temperature Range
Applications
• Camera Phones
• Digital Still Cameras (DSCs)
• PDAs and Notebook PCs
• Smart Phones
Typical Application
2.7V to 5.5V
EN/SET
C1
C2
1µF
1µF
C1+ C1- C2+ C2-
V_IN
V_OUT
C_IN
4.7µF
AAT3172
C_OUT
2.2µF
Flash
LED 1
Flash
LED 2
F1
EN/SET
GND
F2
3172.2005.11.1.1
1