AAT3140_07 Datasheet, PDF (1/16 Pages) Advanced Analogic Technologies – High Efficiency 1X/1.5X/2X Charge Pump for White LED Applications

AAT3140
High Efficiency 1X/1.5X/2X Charge Pump
for White LED Applications
General Description
Features
ChargePump^™
The AAT3140 is a low noise, constant frequency
charge pump DC/DC converter that uses a tri-mode
load switch (1X), fractional (1.5X), and doubling (2X)
conversion to maximize efficiency for white LED appli-
cations. The device produces current levels up to
30mA on each of its four current source outputs to
drive various arrangements of LEDs from a 2.7V to
5.5V input. Outputs may be operated individually or in
parallel for driving higher-current LEDs. A low external
parts count (two 1µF flying capacitors and two small
1µF capacitors at V_IN and CP) make the AAT3140 ide-
ally suited for small battery-powered applications.
The AAT3140 is equipped with AnalogicTech’s unique
AutoBias™ technology which allows individual LEDs
to be powered either by charge pump or battery input,
determined internally and automatically to maximize
the power efficiency even with a large difference in
LED forward voltage.
AnalogicTech's Simple Serial Control™ (S²Cwire™)
digital input is used to enable, disable, and set the
LED drive current with a 32-level logarithmic scale
LED brightness control. The AAT3140 has a thermal
management system to protect the device in the event
of a short-circuit condition at an output pin. Built-in soft-
start circuitry prevents excessive inrush current during
start-up. A high charge pump switching frequency
enables the use of very small external capacitors. In
shutdown mode, the device disconnects the load from
V_IN and reduces quiescent current to less than 1µA.
The AAT3140 is available in the very small, Pb-free
12-pin TSOPJW package.
• V_IN Range: 2.7V to 5.5V
• Tri-Mode 1X, 1.5X, and 2X Charge Pump for
Maximum Efficiency and V_F Coverage
• Drives Low-V_F and High-V_F Type LEDs
• Up to Four 30mA Outputs
• 32-Position Logarithmic Scale with Digital
Control
• Low Noise Constant Frequency Operation
• 1MHz Switching Frequency
• AutoBias Technology
• Small Application Circuit
• Regulated Output Current
• Automatic Soft Start
• No Inductors
• I_Q < 1µA in Shutdown
• 12-Pin TSOPJW Package
Applications
• Color (RGB) Lighting
• Programmable Current Sources
• White LED Backlighting
• White Photo Flash for Digital Still Cameras
Typical Application
V_BATTERY
C_IN
C_CP
1μF
1μF
EN/SET
VIN
C1+
CP
C1-
C2+
AAT3140
C2-
D1
D2
D3
D4
EN/SET
GND
C1
1μF
C2
1μF
D4
D3
D2
D1
3140.2007.03.1.3
1