AWT6332 Datasheet, PDF (4/8 Pages) ANADIGICS, Inc – ZeroICTM PCS/CDMA 3.4V/28dBm Linear Power Amplifier Module

AWT6332
Table 4: Electrical Specifications - CDMA Operation (IS-95 Modulation)
(TC = +25 °C, VBATT = VCC = +3.4 V, VEN = +2.4 V, 50 Ω system)
PARAMETER
MIN TYP MAX UNIT COMMENTS
Gain
Insertion Loss
24.5
-
27 29.5
0.8 1.5
dB
POUT = +28 dBm, VMODE = +2.4 V
VMODE = 0 V
Adjacent Channel Power
at +1.25 MHz offset
Primary Channel BW - 1.23 MHz
-
-51 -46.5 dBc POUT = +28 dBm, VMODE = +2.4 V
Adjacent Channel BW = 30 kHz
-
-70
-
VMODE = 0 V
Adjacent Channel Power
at +2.25 MHz offset
Primary Channel BW - 1.23 MHz
Adjacent Channel BW = 30 kHz
-
-
-59.5 -56.5
-70
-
dBc
POUT = +28 dBm, VMODE = +2.4 V
VMODE = 0 V
Isolation
31
34
-
dB
RFOUT to RFIN_SWITCH,
VMODE = +2.4 V, PA "on"
Power-Added Efficiency
34.5 37
-
%
POUT = +28 dBm, VMODE = +2.4 V
Enable Current
-
<0.1 0.25 mA through VEN pin, VEN = +2.4 V
Mode Control Current
-
<0.01 0.1
mA through VMODE pin, VMODE = +2.4 V
Leakage Current
-
<10 15
VCC = +4.2 V, VEN = 0 V,
VMODE = 0 V or +2.4 V
µA
-
<10 18
VCC = +4.2 V, VEN = +2.4 V,
VMODE = 0 V, Switch Mode
Noise in Receive Band
-
-136 -134 dBm/Hz 1930 MHz to 1990 MHz
Harmonics
2fo
3fo, 4fo
-
-
-40
-45
-30
-30
dBc ^{CW Measurement}
Input Impedance
-
-
2:1 VSWR
Spurious Output Level
(all spurious outputs)
POUT < +28 dBm
-
-
-65
dBc
In-band load VSWR < 5:1
Out-of-band load VSWR < 10:1
Applies over all operating ranges
Load mismatch stress with no
permanent degradation or failure
8:1
-
- VSWR Applies over full operating range
Notes:
(1) PAE and ACP limit applies at 1880 MHz (IS-95 modulation).
4
Data Sheet - Rev 2.1
09/2008