AWT6308R_08 Datasheet, PDF (4/8 Pages) ANADIGICS, Inc – HELP2TM PCS/CDMA 3.4V/28dBm Linear Power Amplifier Module

AWT6308R
Table 4: Electrical Specifications - CDMA Operation
(TC = +25 °C, VBATT = VCC = +3.4 V, VEN = +2.4 V, 50 Ω system, IS-95 uplink waveform)
PARAMETER
MIN TYP MAX UNIT COMMENTS
Gain
24.5
14
14
27 29.5
16
18
16
18
POUT = +28 dBm, VMODE = 0 V
dB
POUT = +16 dBm, VMODE = +2.4 V
POUT = +18 dBm, VMODE = +2.4 V,
VCC = +3.7 V
Adjacent Channel Power
at +1.25 MHz offset
Primary Channel BW = 1.23 MHz
-
-51 -46.5
POUT = +28 dBm, VMODE = 0 V
Adjacent Channel BW = 30 kHz
-
-58
-47
dBc POUT = +16 dBm, VMODE = +2.4 V
-
-52 -47
POUT = +18 dBm, VMODE = +2.4 V,
VCC = +3.7 V
Adjacent Channel Power
at +1.98 MHz offset
Primary Channel BW =1.23 MHz
Adjacent Channel BW = 30 kHz
-
-
-56
-56
-53
-53
dBc
POUT = +28 dBm, VMODE = 0 V
POUT = +16 dBm, VMODE = +2.4 V
Adjacent Channel Power
at +2.25 MHz offset
Primary Channel BW = 1.23 MHz
Adjacent Channel BW = 30 kHz
-
-
-62
-62
-57
-57
dBc
POUT = +28 dBm, VMODE = 0 V
POUT = +16 dBm, VMODE = +2.4 V
Power-Added Efficiency
36
40
-
16
19
-
%
POUT = +28 dBm, VMODE = 0 V
POUT = +16 dBm, VMODE = +2.4 V
Quiescent Current (Icq)
-
15
20
mA through VCC pin, VMODE = +2.4 V
Enable Current
-
0.3 0.8
mA through VEN pin, PA "on"
Mode Control Current
-
0.3 0.8
mA through VMODE pin, VMODE = +2.4 V
Battery Current
-
3
5
mA through VBATT pin, VMODE = +2.4 V
Leakage Current
-
<1
5
µA
VCC = +4.2 V, VEN = 0 V,
VMODE = 0 V
Noise in Receive Band
-
-135 -133 dBm/Hz 1930 MHz to 1990 MHz
Harmonics
2fo
3fo, 4fo
-
-
-43
-55
-30
-30
dBc
Input Impedance
-
-
2:1 VSWR
Spurious Output Level
(all spurious outputs)
POUT < +28 dBm
-
-
-65
dBc
In-band load VSWR < 5:1
Out-of-band load VSWR < 10:1
Applies over all operating ranges
Load mismatch stress with no
permanent degradation or failure
8:1
-
- VSWR Applies over full operating range
Notes:
1. ACPRs and Efficiency Limits at mid-band only.
4
Data Sheet - Rev 2.3
10/2008