AWT6223R Datasheet, PDF (3/16 Pages) ANADIGICS, Inc – WCDMA/GSM/GPRS/Polar EDGE Power Amplifier Module with Integrated Power Control

ELECTRICAL CHARACTERISTICS
Table 2: Absolute Maximum Ratings
ParaMeter
MIN MaX _uNIts
Supply Voltage (VBATT)
-
+6
V
Supply Voltage (VCC_WCDMA)
-
+5
V
RF Input Power (RFIN)
-
10 dBm
GSM/EDGE Output Control Voltage (VRAMP) -0.3
1.8
V
WCDMA Control Voltages (VMODE, VEN)
0
3.5
V
Storage Temperature (TSTG)
-55
150
°C
Stresses in excess of the absolute ratings may cause permanent damage.
Functional operation is not implied under these conditions. Exposure
to absolute ratings for extended periods of time may adversely affect
reliability.
AWT6223R
CEXT2
>+2500 V <-2500 V
WCDMA_IN
>+1500 V <-1500 V
1
VMODE
>+1500 V <-1500 V
2
VEN
3
>+1500 V <-1500 V
DCS/PCS_IN
>+2500 V <-2500 V
4
BS ₅
>+2500 V <-2500 V
TX_EN
>+2500 V <-2500 V
6
VBATT
>+2500 V <-2500 V
7
CEXT1
>+2500 V <-2500 V
8
VRAMP
>+2500 V <-2500 V
9
GSM850/900_IN
>+2500 V <-2500 V
10
22
GND
11
21 ^VCC_WCDMA
>+1300 V <-1300 V
20
WCDMA_OUT
>+1500 V <-1500 V
19 GND
18
DCS/PCS_OUT
>+2500 V <-2500 V
17 GND
16 GND
15 ^CEXT3
>+2500 V <-2500 V
14 GND
13 GND
12
GSM850/900_OUT
>+2500 V <-2500 V
VCC_GSM
>+2500 V <-2500 V
Figure 3: ESD Pin Rating
Electrostatic Discharge Sensitivity
The AWT6223R part was tested to determine the
ESD sensitivity of each package pin with respect
to Ground. Non-ground pins are stressed with 1
positive pulse or 1 negative pulse with respect to
the Ground using the Human Body Model appara-
tus and waveform outlined in JESD22-A114C.01.
Determination of pass or fail is made according to
whether the part passes key RF tests against the
datasheet limits after stress. Results of the test are
presented in Figure 3:
• Rating for WCDMA_IN, VMODE, VEN, and
WCDMA_OUT is +1500V and -1500V;
• Rating for VCC_WCDMA is +1300V and -1300V;
• Rating for DCS/PCS_IN, BS, Tx_EN, VBATT,
CEXT1, VRAMP, GSM_IN, VCC_GSM, GSM_OUT,
CEXT3 and DCS/PCS_OUT is +2500V and
-2500V
It is very important to take all necessary precautions,
listed in Application Notes “ESD precautions for
ANADIGICS GaAs MMIC,” to avoid ESD damage to
Data Sheet - Rev 2.0
3
11/2008