ATS177 Datasheet, PDF (1/6 Pages) Anachip Corp – Single Output Hall Effect Latch

Single Output Hall Effect Latch
ATC
ATS177
„ Features
- 3.5V to 20V DC operation voltage
- Temperature compensation
- Wide operating voltage range
- Open-Collector pre-driver
- 25mA maximum sinking output current.
- Reverse polarity protection
- Package: SIP3, SOT23
„ Applications
- Brush-less DC Motor
- Brush-less DC Fan
- Revolution counting
- Speed measurement
„ General Description
ATS177 is an integrated Hall effect latched sensor
designed for electronic commutation of brush-less
DC motor applications. The device includes an
on-chip Hall voltage generator for magnetic sensing,
a comparator that amplifies the Hall voltage, and a
schmitt trigger to provide switching hysteresis for
noise rejection, and open-collector output. An
internal bandgap regulator is used to provide
temperature compensated supply voltage for
internal circuits and allows a wide operating supply
range.
If a magnetic flux density larger than threshold Bop,
DO is turned on(low). The output state is held until
a magnetic flux density reversal falls below Brp
causing DO to be turned off (high).
„ Ordering Information
ATS177 X - X X X - X
Wafer Body
Blank or
A~Z : if necessary
to specify
Package
P: SIP3
W: SOT23
Lead
L : Lead Free
Blank: Normal
Packing
Blank : Tube or Bulk
A : Tape & Reel
Magnetic
Characteristics
A or B
„ Typical Application Circuit
+12V
D1
R1
2K
U1
1 _{VCC OUTPUT} 3
GND
2 ^ATS177
L1
Q1
NPN
R2
3K
+ _C1
0.47uF
L2
Q2
NPN
+ C2
0.47uF
Brush-less DC Fan
This datasheet contains new product information. Anachip Corp. reserves the rights to modify the product specification without notice. No liability is assumed as a result of the use of
this product. No rights under any patent accompany the sale of the product.
Rev.A6 Jun 23, 2004
1/6