AP1506_1 Datasheet, PDF (1/13 Pages) Anachip Corp – 150KHz, 3A PWM Buck DC/DC Converter

This Anachip version datasheet is replaced
with Diodes Inc. datasheet AP1506
150KHz, 3A PWM Buck DC/DC Converter
AP1506
„ Features
- Output voltage: 3.3V, 5V, 12V and adjustable
output version
- Adjustable version output voltage range, 1.23V to
18V+4%
- 150KHz +15% fixed switching frequency
- Voltage mode non-synchronous PWM control
- Thermal-shutdown and current-limit protection
- ON /OFF shutdown control input
- Operating voltage can be up to 22V
- Output load current: 3A
- TO220-5L, TO263-5L and PDIP-8 packages
- Low power standby mode
- Built-in switching transistor on chip
„ Applications
- Simple High-efficiency step-down regulator
- On-card switching regulators
- Positive to negative converter
„ Pin Assignments
( Top View )
Metal Tab GND
TO263-5L
( Top View )
TO220-5L
5 SD
4 FB
3 GND
2 Output
1 V_{IN (Top View)}
V_{IN 1}
8
Output ₂
7
FB 3
6
SD 4
5
PDIP-8L
5 SD
4 FB
3 GND
2 Output
1 V_IN
GND
GND
GND
GND
„ General Description
The AP1506 series are monolithic IC designed for a
step-down DC/DC converter, and own the ability of
driving a 3A load without external transistor. Due to
reducing the number of external component, the
board space can be saved easily. The external
shutdown function can be controlled by logic level
and then come into standby mode. The internal
compensation makes feedback control have good
line and load regulation without external design.
Regarding protected function, thermal shutdown is
to prevent over temperature operating from damage,
and current limit is to prevent over current operating
of the output switch. If current limit function
occurred and V_FB is down to 0.5V below, the
switching frequency will be reduced. The AP1506
series operate at a switching frequency of 150KHz
thus allowing smaller sized filter components than
what would be needed with lower frequency
switching regulators. Other features include a
guaranteed +4% tolerance on output voltage under
specified input voltage and output load conditions,
and +15% on the oscillator frequency. The output
version included fixed 3.3V, 5V, 12V, and an
adjustable type. The packages are available in a
standard 5-lead TO-220, a 5-lead TO-263 or 8-lead
PDIP.
„ Pin Descriptions
Pin
Name
V_IN
Output
GND
FB
SD
Pin #
TO PDIP
Description
1
1 Operating voltage input
2
2 Switching output
3
5~8 Ground
4
3
Output voltage feedback
control
5
4 _{ON /OFF Shutdown}
This datasheet contains new product information. Anachip Corp. reserves the rights to modify the product specification without notice. No liability is assumed as a result of the use of
this product. No rights under any patent accompany the sale of the product.
Rev.1.3 Oct 24, 2005
1/13