TCS3200 Datasheet, PDF (5/15 Pages) TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS – COLOR LIGHT-TO-FREQUENCY CONVERTER

TCS3200, TCS3210
PROGRAMMABLE
COLOR LIGHT-TO-FREQUENCY CONVERTER
TAOS099A − AUGUST 2011
Operating Characteristics at V_DD = 5 V, T_A = 25°C, S0 = H, S1 = H (unless otherwise noted)
(See Notes 5, 6, 7, and 8). Values for TCS3200 (TCS3210) are below.
PARAMETER
TEST
CONDITIONS
CLEAR
PHOTODIODE
S2 = H, S3 = L
MIN TYP MAX
BLUE
PHOTODIODE
S2 = L, S3 = H
MIN TYP MAX
GREEN
PHOTODIODE
S2 = H, S3 = H
MIN TYP MAX
RED
PHOTODIODE
S2 = L, S3 = L
MIN TYP MAX
UNIT
Output
f_O frequency
lid ^{(Note 9)}
E_e = 47.2 μW/cm²,
λ_p = 470 nm
E_e = 40.4 μW/cm²,
λ_p = 524 nm
E_e = 34.6 μW/cm²,
λ_p = 640 nm
12.5
(4.7)
12.5
(4.7)
13.1
(4.9)
15.6
(5.85)
15.6
(5.85)
16.4
(6.15)
18.7
61%
(7)
18.7
8%
(7)
19.7
5%
(7.4)
84% 22%
28% 57%
21% 0%
43% 0%
80% 9%
12% 84%
6%
27% kHz
105%
a λ_p = 470 nm
Irradiance
v Re responsivity λp = 524 nm
(Note 10)
ill ^{λp = 640 nm}
331
(124)
386
(145)
474
(178)
61%
8%
5%
84% 22%
28% 57%
21% 0%
43% 0%
80% 9%
12% 84%
6%
27%
Hz/
(μW/
cm²)
105%
G _st Saturation
irradiance
A ^{t (Note 11)}
λ_p = 470 nm
λ_p = 524 nm
λ_p = 640 nm
1813
(4839)
1554
(4138)
1266
(3371)
−−
−−
−−
−−
−−
−−
−−
−−
μW/
cm²
−−
s ⁿ f_D
Dark
frequency
E_e = 0
2 10
2 10
2 10
2 10 Hz
m ^{te Nonlinearity}
(Note 12)
a ⁿ _Recovery
o ^{from power}
down
f_O = 0 to 5 kHz
f_O = 0 to 50 kHz
f_O = 0 to 500 kHz
± 0.1
± 0.2
± 0.5
100
± 0.1
± 0.2
± 0.5
100
± 0.1
± 0.2
± 0.5
100
± 0.1
± 0.2
± 0.5
100
% F.S.
μs
c Response
time to out-
put enable
l _(OE)
100
100
100
100
ns
a NOTES: 5. Optical measurements are made using small-angle incident radiation from a light-emitting diode (LED) optical source.
6. The 470 nm input irradiance is supplied by an InGaN light-emitting diode with the following characteristics:
peak wavelength λ_p = 470 nm, spectral halfwidth Δλ½ = 35 nm, and luminous efficacy = 75 lm/W.
ic 7. The 524 nm input irradiance is supplied by an InGaN light-emitting diode with the following characteristics:
peak wavelength λ_p = 524 nm, spectral halfwidth Δλ½ = 47 nm, and luminous efficacy = 520 lm/W.
8. The 640 nm input irradiance is supplied by a AlInGaP light-emitting diode with the following characteristics:
n peak wavelength λ_p = 640 nm, spectral halfwidth Δλ½ = 17 nm, and luminous efficacy = 155 lm/W.
9. Output frequency Blue, Green, Red percentage represents the ratio of the respective color to the Clear channel absolute value.
h ^{10. Irradiance responsivity Re is characterized over the range from zero to 5 kHz.}
11. Saturation irradiance = (full-scale frequency)/(irradiance responsivity) for the Clear reference channel.
Tec ^{12. Nonlinearity is defined as the deviation of fO from a straight line between zero and full scale, expressed as a percent of full scale.}
Copyright E 2011, TAOS Inc.
4
r
www.taosinc.com
The LUMENOLOGY r Company
r