AS1120_1 Datasheet, PDF (11/13 Pages) ams AG – 46-Segment LCD Driver

AS1120
Datasheet - Application Information
CONTROL DIMENSIONS ARE IN MILLIMETERS
SYMBOL
MILLIMETER
MIN. NOM. MAX.
1.60
0.05
0.15
1.35 1.40 1.45
D
16.00 BSC.
D1
14.00 BSC.
E
16.00 BSC.
E1
14.00 BSC.
R2 ^0.08
0.20
R1 0.08
0°
3.5° 7°
0°
11° 12°
13°
11° 12°
13°
c
0.09
0.20
0.45 0.60 0.75
1.00 REF
0.20
SYMBOL
b
e
D2
E2
64L
MILLIMETER
MIN. NOM. MAX.
0.30 0.35 0.45
0.80 BSC.
12.00
12.00
aaa
0.20
bbb
0.20
ccc
0.10
ddd
0.20
Notes:
1. All dimensioning and tolerancing conform to ANSI Y14.5M-1982.
2. Top package may be smaller than bottom package by 0.15mm.
3. Datums A-B and -D- to be determined at datum plane -H-.
4. Dimensions D and E are to be determined at seating plane -C-.
5. Dimensions D1 and E1 do not include mold protrusion. Allowable mold protrusion is 0.25mm per side. D1 and
E1 are body size dimensions including mold mismatch.
6. Detail of pin1 identifier is optional but must be located within the zone indicated.
7. Dimension b does not include dambar protrusion. Allowable dambar protrusion is 0.08mm in excess of the b
dimension at maximum material condition. Dambar cannot be locatedon the lower radius or the foot.
8. Exact shape of each corner is optional.
9. These dimensions apply to the flat section of the lead between 0.10 and 0.25mm from the lead tip.
10. All dimensions are in millimeters.
www.austriamicrosystems.com
Revision 1.05
11 - 13