AS1713 Datasheet, PDF (1/15 Pages) ams AG – Difference Amplifier, 10MHz, 10V/μs, Rail-to-Rail I/O

AS1713
Difference Amplifier, 10MHz, 10V/µs, Rail-to-Rail I/O
with Shutdown
1 General Description
2 Key Features
Data Sheet
The AS1713 is a low cost cmos difference amplifier pro-
viding extended common mode voltage range for a sin-
gle rail 5V supply. Resistor trimming during final test
ensures a typical common mode rejection of 60dB. Low
input bias currents, 10MHz gain bandwidth, low total
harmonic distortion (THD) and a rail-to-rail output drive
capability of typically 200mA (@ 5V supply) provide sup-
port for a number of signal processing applications such
as audio line receivers, ground loop breakers and cur-
rent sensing. Linearity is suitable for 12bit ADC mea-
surement.
A classical single amplifier approach ensures that the
differential gain is determined by a simple ratio of two
internal resistors. A fixed gain of x1 is available.
Single ended input resistance is equalised (10kΩ ±10%)
at each input terminal. This feature provides additional
common mode rejection when long balanced input
cables connect at the input.
A EN pin reduces the quiescent current of the device.
! Constant Output Drive Capability: 50mA
! Rail-to-Rail Input and Output
! Supply Current: 1.6mA
! Single-Supply Operation: 2.7 to 5.5V
! Voltage Gain: 1
! Gain-Bandwidth Product: 10MHz
! High Slew Rate: 10V/µs
! Power-Supply Rejection Ratio: -70dB
! Common Mode Rejection Ratio: -60dB
! No Phase Reversal for Overdriven Inputs
! Unity-Gain Stable for Capacitive Loads: Up to 100pF
! Shutdown Mode Current: 1nA
! MLPD (2x2mm) 8-pin package
3 Applications
The device is ideal for headphone amplifiers with ground
interference rejection, infotainment high drive audio line
buffers with ground interference rejection, audio differ-
ential-to-single-ended conversion and instrumentation
amplifier back-end.
Figure 1. Block Diagram
VDD
INN
R1
R2
SENSE
EN
AS1713
–
OUT
+
INP
R3
R4
REF
VSS
www.austriamicrosystems.com
Revision 1.01
1 - 15